资源列表
kuopin
- 混合扩频DS/FH仿真程序，从原始信号通过伪随机码，跳频码转变为混合扩频信号，再依次解跳解扩，最后通过低通滤波器恢复出信号。-Hybrid spread spectrum DS/FH simulation program, from the original signal by pseudo random code, frequency hopping code into a hybrid spread spectrum signal, and then hopping despreading,
FPGA
- FPGA based water level control
pskmod1
- 这是PSK在MATLAB上调制的源程序！希望大家可以用的上！-This is the MATLAB PSK modulation on the source! Hope that we can use!
Ifleap
- 这是一个判断某一年是否为润年的程序，运行可执行程序Ifleap.exe后，输入具体的年份， 可输出是本年是否为闰年的提示信息。-This a judgment of whether a particular year of a leap year, the running executable Ifleap.exe after importation of specific year, the output this year is a leap year if the message.
systime
- 汇编语言课程设计... ...systime
music
- 这是一个汇编语言编写的音乐程序!它利用电脑蜂鸣器演奏出音乐!-This is a compilation of music written procedures! It play out the use of computer beep music!
1
- P1口LED灯实现各种渐变效果，有真正的流水灯程序！！1-P1 port LED lamps to achieve a variety of gradient effects, there is a real water light program! ! 1
project
- Puzzle Game is Assembly Language
19521213545
- 这是一款易语言远吗开源技术支持免费的石智勇 如果没有注册吗可以通过注册使用-This is an easy language far behind open source technology support free Shi Zhiyong If not registered you can sign up to use
lab3
- 编写程序，将开关的状态读入计算机，并将它通过输出端口驱动发光二级管显示相应的状态。 输入端口74LS244和输出端口74ALS273的地址均为6460H。 -Write a program that will switch the state to read into the computer, and output ports drive LED display the corresponding status. The address of the input port 74L
mydcm1
- 基于verilog的FPGA里dcm模块分频偏移程序-dcm Frequency offset