资源列表
Spline
- Source code for calculate and draw spline by use of co-processor
MPC564SCISPI
- mpc563 串行通讯程序和串行外围设备通讯程序代码-mpc563 program code
jieshou
- 基于892051红外遥控电子密码锁,接收部分程序
decoder3_8
- 3-8decoder实现fpga功能,3-8decoder实现fpga功能-3-8decoder
reader
- 基于iso14443协议的手持读卡(巡更器)程序-Iso14443 protocol based on hand-held card reader (Patrol device) program
1
- 程序在局域网内自动更新,可以保障公司部门之间数据一致性。-Program will be updated within the local area network (LAN), can guarantee data consistency between the corporate sector
The-use-of-DEBUG
- 实验一 DEBUG的使用实验内容: 1、利用DEBUG程序中的“E”命令,将两个多字节数“12345678H”和“FEDCBA98H”分别送入起始地址为DS:0200H和DS:0204H两个单元中。 2、分别用直接寻址方式和寄存器间接寻址方式编写程序段,实现将DS:0200H单元和DS:0204H单元中的数据相加,并将运算结果存放在DS:0208H单元中。-The experiment a DEBUG use experimental contents: 1, the use
dcds_flight
- 航空客运订票系统 内含各个小的分程序 有助于理解 -air passenger booking system containing all the small hours helps to understand
Cadisassembly-matching
- 在进行C语言Softice或者Windbg调试时,需要懂的C语言与汇编的互相翻译。上传项目就是对应的练习。-C-Assembly translation is key for debugging on Softice/Windbg. The project uploaded will give some hints for practicing
PID
- 增量型PID算法汇编程序,增量式PID算法的输出量为 UnΔ = Kp[(en-en-1)+(T/Ti)en+(Td/T)(en-2*en-1+en-2)] 式中,en、en-1、en-2分别为第n次、n-1次和n-2次的偏差值,Kp、Ti、Td分别为比例系数、积分系数和微分系数,T为采样周期。
demo16-LCD1602
- 51单片机的LCD1602汇编语言程序,完整工程-51 MCU LCD1602
RTC_power_test
- 用于进行RTC功耗测试的程序,其他功耗测试也可借鉴,单片机程序,采用C与汇编语言编写-RTC power used for test procedures, and other power test can also learn lessons, SCM, using C and assembly language
