调用这个VI的上层VI在调整好界面后，一定要将前面板的最小尺寸设置为当前前面板大小，如下图所示：

方法是调整前面板为需要大小，然后通过"文件">>"VI属性">>"窗口大小"，也可以直接CTRL+I再选择“窗口大小”，点击“设置为当前前面板大小”即可，

至于下一个“在不同分辨率下保持窗口比例”的选项，试过不勾选也不会出什么问题，以防万一，还是勾选上了。最后点击确定完成。

使用时直接将这个子VI放入到需要显示前面板的程序的后面板中即可（即直接调用）。如果A调用B，B再调用这个程序时，只对B起作用，如果需要对A也起作用

需要在B的后面板也加入这个程序。

这个VI只有错误输入输出，也可以不连接。-Call this VI VI in the upper adjust interface, be sure to set the minimum size of the front panel to the current size of the front panel, as shown below:

Method is to adjust the size of the front panel as required, and then "File">> "VI Properties">> "window size", it can CTRL+ I and then select "Window Size", click "Settings for the current size of the front panel" that is can,

The next "to maintain the window in different resolution ratio" option, tried not check out without any problems, just in case, or check on the. Finally click OK to complete.

When used in this sub-VI directly into the need to show that the procedure before the panel after panel, you can (or direct calls). If A calls B, B and then call this procedure, the only work on B, if A is also work on

B, after the panel needs to have joined the program.

This VI only error input and output, you can not connect.