搜索资源列表
fab
- 波信号发生及测量表(10~90Hz,步长5Hz) P23输出、P32输入;前两位显示输出频率,后两位显示输入的测量值 UP键增加设定频率值,DOWN键减少频率设定值 -Wave signal and measuring table (10 ~ 90Hz, step 5Hz) P23 output, P32 input two display output frequency, the latter two show the measured value input UP but
pwm
- PWM信号发生及测量仪(50Hz,10~90 占空比可调节) P23输出、P32输入;前两位显示输出占空比,后两位显示输入的测量值 -PWM signal generation and measurement (50Hz, 10 ~ 90 duty cycle adjustable) P23 output, P32 input two shows the output duty cycle, the latter two show the measured value input
001
- 信号发生(请认真阅读您的文件包然后,直接运行就可以,需要labview8.5)-signal generation
pules
- 51脉冲信号发生器,实现脉冲信号输出!简单但好用!-51-pulse signal generator, to achieve pulse signal output! Simple but good!
color
- 此程序为EDA—VGA彩色信号发生和控制程序-This procedure for the EDA-VGA color signal generation and control procedures
ZX
- 本系统以51单片机及FPGA为控制核心,由正弦信号发生模块、功率放大模块、调幅(AM)、调频(FM)模块、数字键控(ASK,PSK)模块以及测试信号发生模块组成-The system of 51 single-chip and FPGA for the control of the core module by the sinusoidal signal, power amplifier module, AM (AM), frequency modulation (FM) module, dig
cw
- 用ip核设计的信号发生程序,altera的 用ip核设计的信号发生程序,altera的 用ip核设计的信号发生程序,altera的 用ip核设计的信号发生程序,altera的-signal source for altera by ip coresignal source for altera by ip coresignal source for altera by ip coresignal source for altera by ip coresignal source for alte
si4133
- 采用集成化(包括VCO PLL LPF)的锁相环进行点频信号发生的的源代码-The use of integrated (including VCO PLL LPF) for the phase-locked loop frequency signal occurred at the source code
MAX038
- 介绍了一种基于MAX038的宽频程控波形发生器。它可以产生三角波、方波和正弦波.输出频率范围为1.6 kHz~40MHz。与其他类型的波形发生器相比,该系统具有程控调节输 出频率的突出优点:以单片机和集成波形发生芯片MAX038为核心构成硬件电路能自动地反馈控制输出频率:采用上位机(Pc机)的软件设置波形发生器的各种参数并实时显示输出频率值。该波形发生器已经成功地应用于超声波发射换能器中。-Introduced a program based on the MAX038 waveform g
BCS
- 压缩传感是一个从2006年左右开始兴起的研究领域,它关注于如何采样信号,也就是信号的采样方式或者压缩方式。通过设计一种特殊的采样方案,可以使得采样频率降低为信号的“信息率”,而不是传统的奈奎斯特采样率,于是,实际的采样率可以大大低于奈奎斯特频率,却只损失很少的信息量,依然保持了充足的信息量足以恢复出采样前的原始信号。这个研究思想挑战了奈奎斯特频率的理论极限,会对整个信号处理领域产生极其深远的影响,同时,信号处理的许多应用领域也会随之发生根本性的发展和变化。 -Compressive sens
signal_and_display
- 信号发生电 路及 数码管 频 率显示电路-Signal frequency control circuit and digital display circuit
AD9851_DDS
- 利用AD9851信号发生产生正弦波的程序,包含51的和MSP430的程序!-AD9851 using sine wave signal generated procedures, including 51 of the procedures and MSP430!
xinhao.c
- dds信号发生器程序,可以实现70Mhz的正弦波发生-dds c program
4bitlock
- 本文以在PFGA芯片中实现一个简单的可控正弦信号发生模块的设计为例,详细介绍DSP Builder的使用方法,从而有介绍一种另外PFGA—DSP算法的程序方法。-In this paper, in the PFGA chip to achieve a simple sinusoidal signal control module design as an example, detailing the use of DSP Builder methods, thus introducing a k
SignalModule
- 信号发生模块 附带电路图和C程序代码 挺经典的-Signal module with circuit diagram and C code
wimax_ss_gen_n
- omnet++的wimax信号发生源代码-omnet++ The source code for wimax signal
wimax_ss_gen_n
- 做了很久的用omnet++仿真器的wimax信号发生程序,希望对做通信仿真的朋友们有用-Done a long time with omnet++ simulator wimax signal process, want to make friends, useful communication simulation
AD9834DRIVER
- 函数信号发生芯片AD9834的基本驱动与简单应用。-AD9834DRIVER
icetek_c6713_peripheral
- 瑞泰创新(icetek_c6713_A)实验箱(/开发板)的外设控制实验,包括:发光二极管阵列显示实验,液晶显示器控制显示实验,键盘输入实验,音频信号发生实验,直流电机控制实验,步进电机控制实验-Iectek Innovation (icetek_c6713_A) experimental box (/ development board) of the peripheral control experiments, including: light-emitting diode array d
PWM
- PWM原理 2、调制器设计思想 3、具体实现设计 一、 PWM(脉冲宽度调制Pulse Width Modulation)原理: 脉冲宽度调制波通常由一列占空比不同的矩形脉冲构成,其占空比与信号的瞬时采样值成比例。图1所示为脉冲宽度调制系统的原理框图和波形图。该系统有一个比较器和一个周期为Ts的锯齿波发生器组成。语音信号如果大于锯齿波信号,比较器输出正常数A,否则输出0。因此,从图1中可以看出,比较器输出一列下降沿调制的脉冲宽度调制波。 -PWM principle 2