搜索资源列表
LCD-display-stopwatch
- 用c语言写的程序，用单片机实现LCD 显示秒表的功能-With c language program, with MCU function LCD display stopwatch
clock2
- 89c51的单片机，实现计时功能，相当于秒表，显示分秒，可以用开关实现分，秒的增加-89c51 microcontroller to achieve the timing function, the equivalent of a stopwatch, display minutes and seconds can be achieved with the switch points, second to increase
rar
- 51单片机实现的时钟，有调时和秒表功能，用vhdl语言实现-51 MCU clock, and stopwatch function when it has been argued, with vhdl language
AT89C52
- AT89C52单片机学习板，数码管秒表实验。-AT89C52 single-chip digital stopwatch test
1
- 中断时钟程序，可以让初学者学习单片机内部的中断，还可以制作生活上用的秒表-Interrupt clock program that allows beginners to learn the internal microcontroller interrupt, you can also make daily life with the stopwatch
yejin-miaobiao
- 基于msp430单片机的秒表及12864函数，经过149及169验证的-Msp430 microcontroller based function stopwatch and 12864, after 149 and 169 validation
shizhong
- 单片机多功能电子时钟 有年月日 闹钟 秒表 倒计时 还有串口通信 音乐播放等功能-Single-chip multi-function electronic stopwatch alarm clock with month, day countdown also serial communication functions such as music playback
8051Pproteus-116
- 《单片机C语言程序设计实训100例——基于8051+Proteus仿真》案例压缩包 第 03 篇 综合设计 16 1602LCD显示的秒表-" Microcontroller C Programming Language Training 100 cases- based on 8051+ Proteus simulation," Case No. 03 compressed package integrated design 16 1602LCD display stopwa
miaobiao
- 用汇编语言写得99秒得秒表 简单易懂 适合初学单片机的人参考 有按键功能可以对时间进行暂停和启动-Assembly language written 99 seconds with a stopwatch was easy to understand reference for beginners who are key SCM functions can pause and start the time
99miaobiao
- 这是基于单片机开发板，用单片机控制数码管，显示秒表功能的-This is based on microcontroller development board, with chip control digital display stopwatch function
2
- mega16 单片机 cvavr 秒表，两个IO口串行输出段码，PA0接164的AB(即12号引脚),PA1接CLK(8),CLR接高电平，QH-QA接a——p，PC0-PC5接LED的6到0位控端-mega16 SCM cvavr stopwatch, two serial output section of the IO port code, PA0 received 164 AB (that is, 12-pin), PA1 then CLK (8), CLR then high, Q
time
- 用单片机及位LED数码管显示时分秒，以及24时的计时方式运行。能够整点提醒（短蜂鸣，次数代表整点时间），使用按键开关可实现时，分调整，秒表/时钟功能转换，省电（关闭显示）及定时设定提醒（蜂鸣器）等功能-With the microcontroller and LED digital tube display minutes and seconds, and 24 hours of run time. Reminded that the whole (short beep, the number
Msecond
- 秒表计 数字式秒表 led显示 单片机 80c51 汇编语言 可手动启停-Stopwatch digital stopwatch count led display microcontroller 80c51 assembly language can manually start and stop
miaobiao
- 十速单片机，秒表源代码，内有原理图，说明。-10-speed microcontroller, stopwatch source code, there are schematics, instructions.
Digital-calendar-circuit
- 本系统采用STC89C52单片机和DS1302配合，实现实时时间日期和星期的保存和显示。系统中还有一块1602显示屏，用以显示系统中所需的符号和时间日期。另外系统中还装有4个独立式键盘，用于系统操作与控制。并接一个直流蜂呜器和一个交流蜂呜器，用以进行音响提示。DS1302可以实现对系统是的时、分、秒，日期和星期等信息的保存，使系统在掉电的情况下仍然能够准确的保存并运行时间信息。利用单片机的定时器，实现了倒计时和秒表功能的设计。-Digital calendar circuit
Stopwatch
- 用51单片机做一个秒表 ，液晶显示秒、分、时-Make a stopwatch with 51 single-chip, liquid crystal display seconds, minutes, hours
protuesmiaobiao
- 采用Proteus 等仿真软件设计一个秒表电路并编程实现，详细要求如下： 要求单片机驱动一个两位的LED数码管，系统带一个按键，一个蜂鸣器。正常情况下LED数码管显示初始数值00，按下一次按键，秒表开始走时，每秒更新一次时间并显示。再按下一次按键，走时停止，显示当前秒信息。再按一次，秒表清零，重新回到显示初始00值并停止。每次按键时，要求蜂鸣器响0.5秒。 -Proteus used a stopwatch and other circuit simulation software de
WATCH_ASM51
- EL-8051-III单片机实验系统调试通过。6位数码管秒表程序。动态扫描显示。汇编源程序。-EL-8051-III chip debugging through the experimental system. 6 digital stopwatch program. Dynamic scan. Assembler source.
EEPROM
- AT24C02，利用定时器产生一个0~100秒变化的秒表，并且显示在数码管上，每过一秒将这个变化的数写入EEPROM内部。断电后再次接通电源，单片机先从EEPROM中将原l来写入的数据读出，接着此数继续变化并显示在数码管上 。P1口接数码管为选，直接由单片机I/O口控制；P0口接573，控制段选。-AT24C02, the use of timers to generate a change from 0 to 100 seconds stopwatch, and displayed on th
miaobiao
- 将单片机和数码管连接，下载此程序，可以实现倒计时，自己做一个秒表-for counting time