搜索资源列表
BLCD
- 无叶电机 方案,可识别电机异常,过载,输入电源异常等,并在故障发生后进行相应的保护。如果可能,还可在异常恢复后,重新恢复工作。同时,还可增加红外遥控,数码管显示,液晶显示等人机交互界面。可实现自然风,定时功能,预约,智能控制等功能。 主要应用的无叶风扇参数: 输入电压:220AC 电机:310VDC,8200RPM,45W、直流无刷无传感器控制方案 为精确控制电机转速,通常需要在直流无刷电机上增加位置传感器(例如:霍尔传感器)。控制器根据传感的信号,进行相应的控制
shumaguan
- 单片机驱动4位数码管实现个十百千万循环计数。有的数码管不亮是因为硬件的问题。可能是硬件功率太大了。-Microcontroller to drive 4 digital tube ten Millions of cycle counting. Some digital tube does not shine because of hardware problems. May be hardware too much power.
CH451-C
- ch451驱动程序 数码管 条形数码管的c示例程序-the ch451 drive program
C51_clock
- 51单片机,用DS1302实现数码管时钟(可调节年月日周时分秒)+闹钟(定时器驱动speaker,"两只老虎"),用DS18B20实现温度测量。实验板上功能调试OK,并带中文说明。-51 single-chip, using the DS1302 & digital tube clock (date can be adjusted)+ alarm clock (timer-driven speaker can be adjusted), with the DS18B20 temperature
shumaguan
- 利用单片机电量数码管的驱动程序 四位八段共阳极数码管 -Four eight out of the use of digital control of single-chip power driver anode digital tube
shumaguan
- 数码管的静态显示程序,基于keil的proteus驱动程序。-Static digital tube display program, based on the keil proteus driver program.
shumaguan
- keil编程,驱动C52单片机实验4位8段数码管的数字显示程序。-keil programming, drive the C52 single-chip experiment four 8-segment LED digital display program.
max7219
- max7219 与8051 单片机通讯程序 只用3io驱动8位数码管-max7219 and 8051 communications program is only 8 3io drive digital tube
7290
- 本程序是基于LM3S1138微处理器的,是周立功公司的7290B键盘和数码管扫描的驱动程序及其实例-This program is based on the LM3S1138 microprocessor the ZLG 7290B keyboard and digital tube scan driver and its instance
tm1629
- tm1629 驱动数码管 按键 驱动程序-Tm1629 drive digital tube buttons driver
AT89C2051-Realtime-Timer
- AT89C2051单片机驱动4位共阳数码管做的实时时钟的程序,采用12M晶振,计时精度相当不错。-AT89C2051 microprocessor-driven real-time clock program, 4 Yang digital pipe 12M crystal timing accuracy is quite good.
use_74HC595
- AT89S52单片机上驱动两片级联74HC595点亮8位数码管,开发板上可用,里面含原理图。-Drive two cascaded 74HC595 lit 8 digital tube, AT89S52 MCU development board is available, which contains the schematic.
74HC595_20120712
- AT89S52单片机上驱动两片级联74HC595点亮8位数码管,开发板上可用,里面含原理图。-Drive two cascaded 74HC595 lit 8 digital tube, AT89S52 MCU development board is available, which contains the schematic.
linux2.4-driver
- 用于新手熟悉嵌入式Linux设备驱动开发方法,驱动LED灯,七段数码管,和按键的代码-For the novice familiar with the embedded Linux device driver development, code-driven LED lights, seven segment LED, and buttons
8056600tm1668
- TM1688.ZIP数码管显示驱动,基于TM1668的数码管显示驱动-TM1688.ZIP digital tube display driver
VGA_CCD531
- 本文围绕一个包含Nios II软核处理器的可编程片上系统展开数码相机的样机设计。论文首先对样机所要达到的整体功能进行了规划,接下来并行开展了软硬件设计。在硬件方面,充分利用了所使用平台提供的SD卡插槽、键盘、数码管、SRAM等各种硬件资源,并用Verilog HDL硬件描述语言设计了样机系统所需要的VGA接口控制器、CMOS图像传感器接口控制器以及VGA显示存储器;在软件方面,本文基于Nios II软核处理器用C语言实现了SD卡的驱动、FAT文件系统的移植、VGA显视器的驱动以及BMP图片文件的
shenyanghuagong
- 利用74595驱动数码管显示。对单片机通过AD转换来的电压进行显示-74595-driven digital display. Microcontroller through the AD converter to the voltage display
ch452a
- IIC总线协议芯片CH452驱动代码,配合数码管和按键,适合快速移植。-IIC bus agreement CH452 chip driver code, with digital tube and buttons, suitable for rapid transplantation.
Ultrasonic-Ranging-experiment
- 超声波测距实验,用单片机stc89S52驱动,数码管显示。原创程序,非常方便!-Ultrasonic Ranging experiment, the digital display!
MAX7219
- LED数码管MAX7219驱动代码,只有一个函数进行地址和数据的传递,很方便-LED digital tube MAX7219 driver code, only one function for address and data transfer, it is convenient