搜索资源列表
51io-uart
- 51单片机用io口模拟串口收发数据 实现串口功能-51 io simulate usrt
uart
- 51单片机IO口模拟串口程序,已经测试过,接收发数据都正常。稍微修改后也可以应用与其它单片机上。-51 microcontroller IO port analog serial procedures have been tested, receiving hair are normal data. Slight modification can also be applied with other microcontroller.
delay_uart
- 通过单片机的普通IO口,模拟uart串口通信,可以工作在9600的波特率下,调试使用晶振为11.05926M-Through the MCU IO port, simulation UART serial communication, can work at 9600 baud rate, debugging using the crystal oscillator for the 11.05926M
42X0_Uart
- msp430F42X0 TA模拟uart发送程序-msp430F42X0 TA analog uart sending program
UART0407
- ise平台模拟UART,并与PC机实现收发(+1)-ISE platform simulation UART and transceiver.
UART
- 使用Keil和proteus进行单片机UART串口的模拟,包含了Keil程序和proteus仿真图,适合初学者-Keil and Proteus simulation of single-chip UART serial Keil procedures and Proteus simulation map, suitable for beginners
AVR与PC虚拟串口
- Atmega8串口测试程序,适合初学者,使用Atmel Studio 6.0编译通过,使用proteus 7.7模拟,串口输入、输出。test.atsln为Atmel Studio 6.0工程文件,uart.DSN为proteus文件
DHT11
- STC15F104W单片机,DHT11测温程序,通过模拟UART进行数据传输,可以与MCU或上位机连接。使用方便。Keil4-STC15F104W microcontroller, DHT11 temperature program, by simulating the UART for data transmission, can be connected with the MCU or PC. Easy to use.
STC-Uart-2
- 使用I/O口模拟两个串行口的发送与接收,验证正确-Simulate two serial ports
UART
- USB转无线串口,由ATMEGA8的软件模拟SUB(AVR309)做了个USB转串口,以NRF24L01传送!,接收以STC12C5604AD为主机,有原理图及PCB与程序-Wireless USB to serial port, the ATMEGA8 software simulation SUB (AVR309) made 愠 USB to serial port to send NRF24L01! , Receives STC12C5604AD host, schematic and P
One-Wire-Bus
- PIC16F877A单片机上实现用一个GPIO来模拟UART的半双工数据传输-PIC16F877A based, using one GPIO to simulate the half duplex UART communication.
uart
- 基于verilog语言,使用FPGA对串口功能进行模拟与实现-Based verilog language, use the serial port function simulation and FPGA implementations
uart_fifo
- FPGA模拟UART,实现对自发自收. -simulating interface of uart on the fpga
UART
- 单片机MSP430开发,定时器A0模拟串口通信-MSP430 microcontroller development, simulation serial
2-PCA-UART-
- 使用STC15系列单片机模拟双串口。-Use STC15 Series MCU simulation dual serial ports.
REAS-UART-DELAY
- 这是一个基于stm32的红外测温程序,里面用到了模拟i2c的读取。-This is a program based on stm32 of infrared temperature measurement, which uses a simulation i2c read.
UART
- 一些mcu(微处理器)没有硬件异步串行口(UART)为了组网,只能用软件模拟 异步串行口(UART)-Some mcu (microprocessor) no hardware asynchronous serial port (UART) for networking, can only simulate asynchronous serial port software (UART)
1-SDRAM
- 串行接口是最简单的一种通信方式,串口通信有两种方式,一种是同步串行,如SPI接口;另一种则是异步串行,即我们所说的UART。这个项目向大家展示了如何使用FPGA来模拟UART收发器。-uart fpga verilog
GPIO_UAR_SC91F722
- GPIO模拟UART收发数据,单片机赛元SC91F722,开发环境KEILC51,工程正常运行-Sai Yuan microcontroller GPIO analog UART send and receive data, development environment KEILC51, the normal operation of the project
test-Timer-to-Uart2--successed
- msp430f4152 TimerA模拟UART串口通信,不同定时器的不同通道-Msp430f4152 TimerA simulate UART serial port communication