搜索资源列表
Base_Can_Temp_scan
- 基于CAN总线的温度检测节点设计 本文介绍了一种应用LM35温度传感器和PICMicro的温度检测节点的设计方案，用于检测在模拟汽车电子点火的过程中，电子点火模块的核心模块温度和环境温度，将阐明模块结构、工作原理及采样值量化的方法。
wendudeBCDmaxianshi
- 温度的BCD码显示 在0809上显视的是电压值，所以必须将电压转换成温度值。LM35传感器的电压温度特性为“10mV/摄氏度”，经放大电路放大四倍后为40mV/摄氏度，因此对于255来说，每个数代表了20mV，也就是说电压值中的每个00000002代表了温度值中的00000001，由此可编出一张BCD码转换表，此部分程序如下：
LM3SLib_UART_FIFO_RxInt
- lm35 与lpc2000系列 模块的串口通信程序示例代码-lpc2000 series lm35 module and serial communication program sample code
couple
- 热电偶是应用最广泛的一种温度传感器。利用单片机对数字信号处理，并且将处理后的数字信号转换成测量端的真实值，通过LCD动态显示。同时键盘输入设定不同类型热电偶的分度表，能对各种工业热电偶冷端进行温度补偿从而提高温度测量精度，在工业温度控制中有普遍意义。 该文件是项目的源程序。带proteus仿真。-Thermocouple is the most widely used as a temperature sensor. The use of digital signal processing si
adc2
- analog input from temperature sensor lm35 comes and adc of at mega32 converts output to digita.digital data is shown to seven segment display.the digital output controls 4 valves
Temperatursensorpalha1_ventilator
- This programm uses ni 6008 A/D board and the lm35 temperature sensor
LAB7
- PIC C CODE (MPLAB), This Code can be used to Work with a LCD Display and the built in ADC, in the code the ADC is set to get temperature from a LM35 temperature sensor, and it also receives data from the RS232 port and show it in the LCD Display.
SmartLogger
- DataLogger, with DS1307 and LM35.
10BitAD16877
- PIC单片机16877a的10位AD转换模块,含LM35温度检测,包括仿真文件,C源文件和MPLab项目文件-10-bit PIC microcontrollers 16877a AD converter module, containing LM35 temperature detection, including simulation files, C source files and project files MPLab
TEMPAT89C51
- Temperature Transducer LM35
code_cal
- LM35 to 3 digit 7 segment atmega16 cvavr
LM35
- pomiar napię cia (temperatury)
PIC-16F877A-temperature-meter
- A Four Chanel Temperature Meter using PIC 16F877A and sensor LM35. Output value on LCD 16x2. Can setup "Alarm-Temp" for each chanel.
report
- Digital Thermometer Sensor: the IC LM35 has been used as the temperature sensor, which produces an analog output. This analog output is converted to digital data by passing it through the 0804 Analog to Digital Converter. The 89S52 Microprocessor is
ABC
- automatic fan control with PID using LM35
test_LM35
- Example Arduino program that reads temperature from a LM35 sensor. Must be compiled and tested with the official Arduino IDE, that can be downloaded at http://www.arduino.cc/.
Saat-Tarih-Derece-7Segment-Ortak-Anotlu-Dosyalar.
- Time & temparature display with LM35 or DS1302.-Time & temparature display with LM35 or DS1302.
ADPEEPROMPmodbus
- STC12C5204AD单片机开发板上实现modbus协议，通过协议可以返回电压转换及lm35获取的温度，并设置PWM占空比，设置EEPROm中数据，06模式支持广播模式，在3块单片机开发板联合的情况下试验通过 -STC12C5204AD microcontroller development boards implement modbus protocol, protocol can be returned by the voltage conversion and lm35 to obt
TEMPRATURE
- this assembly project and simulation file is about temprature measurment by LM35 temp. sensor