搜索资源列表
DRSSI
- 针对煤矿井下巷道狭长,信号多径效应明显,接收信号强度(RSSI)测距算法受井下环境影响大,定位精度低的情况,提出了一种信标节点链式部署结构下的动态RSSI测距算法,该算法以信标节点间的距离和它们间测量到的RSSI值为参考,计算巷道内实际环境下的路径衰落指数,以提高RSSI测距算法对环境的适应性。-A dynamic RSSI location algorithm is proposed based on the beacon nodes chain deployment of tunnel Wi
multiwall_model
- This example of multiwall model for indoor propagation model. Click on the location of transmitter and press enter,then path loss colour map will shown in figure-This is example of multiwall model for indoor propagation model. Click on the location o
VolcanoIntegrationSample
- C#使用Volcano射线跟踪模型计算通信系统的路径损耗值的实例-C# uses Volcano ray-tracing model of path loss communication system, the value of an instance
aaaa
- 把地理区域分成一个个小区,蜂窝系统在该区域内提供无线覆盖。把可用的频谱分成很多信道,每个小区分配一组信道。使用频分双工(FDD)。在小区间进行频率利用,N个小区构成一个簇,簇间进行频率复用。定义了传播特性(信道参数)以及同频小区的位置。信道的参数包括:小区半径,路径损耗指数,以分贝为单位的对数正态阴影的标准差,基站发射功率级,移动台发射功率级,每个小区的扇区数,扇区化天线的正反向比,要仿真的瞬时位置的组数,同频干扰阈值。-To a geographical area is divided int
CP0801
- 超宽带脉冲幅度调制路径损耗的计算,与其他的几个共用-Ultra-wideband pulse amplitude modulation path loss calculations, and some other common
Doppler
- A signal is transmitted using a carrier frequency of 900 MHz. It is transmitted through a multipath channel which can be modelled as Rayleigh fading. Assumingthe Dopper spread as 10Hz and the number of multipaths as 10, generate the Rayleigh
outage_good
- MATLAB code for outage probability.
Vistools
- This tool is similar to the C/N tool but calculates Power Flux Density (PFD) and Equivalent Power Flux Density (EPFD) rather than C/N, and hence is based upon spreading loss rather than free space path loss.
Hcoef
- 计算水平边缘绕射系数,并计算反射路径损失-Calculate the level of the edge diffraction coefficient, and calculate the reflection path loss
Optimized-Cell-Planning
- In this paper, an optimized cell planning for path loss reduction has been proposed.
pathloth
- WCDMA单蜂窝网的路径损耗 cost231-hata模型-WCDMA single cellular network model of path loss cost231-hata
RadioWORKS_2.0_Installer
- Simulation tool for calculating various anteena paramenters like path loss etc
ccir
- 基于matlab的ccir传播模型的路径损耗的仿真的程序,此程序可以在matlab上清晰的看见仿真的图形。-Based on the matlab ccir propagation models of path loss of simulation program, the program can clear to see in matlab simulation graphics.
3.5GHz--channel-measurements
- 在3.49-3.51GHZ频段内的典型中国城市环境下,地面信号衰落仍服从经典的指数对数分布。在中度误差(σx =10.291)下,路损指数在3.1-3.7之间。半径2公里的小区内,RMS时延在3-4微秒之间;典型的办公室环境中,存在直达径时RMS时延小于0.1微秒。在城市环境中,多径现象很明显,主要由高层建筑物引起,并以簇的方式存在。在城市中低速移动条件下(接收机移动速度小于100 Km/h)某一强径的生存时间通常超过10分钟,但相对到达时间会发生滑动。单一小区内的传播环境具有一定相关性,如果存
TS36942PathlossModel
- 3GPP LTE中TS36942路径损耗模型的源程序代码-TS36942 3GPP LTE path loss model in the source code
DMERR
- 一种基于动态路径损耗指数的最小能耗中继路由 (Dynamic Minimum Energy Relay Routing,DMERR)算法,该算法能够获取巷道内各处准确的路径损耗指数,准确计算巷道内每处的最佳通讯距离,从而节省通信能量。-the Minimum Energy Relay Routing (DMERR) algorithm which is based on dynamic path loss parameter is proposed, this algorithm can sav
pathdef
- PATH LOSS MODELS FOR FEMT-PATH LOSS MODELS FOR FEMTOO
sim
- -latlon2km.m : to find distance between two longitude-latitude coordinate -fresspaceloss.m: to calculate freespace path loss - cazacseq.m: to generate cazac sequence - pusc.m : to generate index for pusc in wimax - FCH generator: to generate
Path-Loss-Models-Paper-1
- Pth loss propaagation model for mobile radio channel
path loss
- 无线信道建模,路径损耗及正态阴影模型源代码,可出图,(Path loss Wireless channel modeling)