搜索资源列表
同有SPI接口的器件进行通信对SPI接口器件的读写控制vhdl源程序
- vhdl实现spi可以同有SPI接口的器件进行通信对SPI接口器件的读写控制vhdl源程序，fpga cpld-vhdl spi can achieve devices with a SPI interface to communicate with devices on the SPI interface to read and write vhdl source code control
SPI_controller
- SPI serial flash ROM的verilog源代码, 针对winbond W25x16,已经经过逻辑验证,并实际用在芯片设计中,作为一个模块,正常工作.-SPI serial flash ROM in verilog source code for winbond W25x16, logic has been verified, and actually used in chip design, as a module to work.
SPI_TEST
- The Serial Peripheral Interface Bus or SPI bus is a synchronous serial data link standard named by Motorola that operates in full duplex mode. Devices communicate in master/slave mode where the master device initiates the data frame. Multiple slave d
neek_alternate_sd_card_controller
- This SPI-mode SD Card controller is a free SOPC Builder component that can be used in any SOPC Builder system. The included example design runs on the Nios II Embedded Evaluation Kit, Cyclone III edition (NEEK).-This SPI-mode SD Card controller is a
MTDB_SYSTEM_CD_V1.0
- ALTERA Nios II Embedded Evaluation Kit开发板制造商(terasic)提供的多媒体显示板（Terasic Multimedia Touch Panel Daughter Board (MTDB)）扩展开发包。 里为有两个开源的例子 1.MTDB_SD_Card_Audio,从SD卡中读取WAV文件然后通过DA播放，这个对不SD Card的初学者非常的有用，可以知道使用FPGA SPI来读写SD CARD。 2.MTDB_Systhesiz
AT24C08_Controller
- AT24C08 is a memory controller for SPI 8Mb memory
get_6675_temp_2
- MAXII 240 CPLD和6675 开发的0-1023.75度的温度传感数据采集系统，用seg7 LED显示，精度0.25度。探头是K型测温线，Quartus II 6.0调是通过，在cpld开发板上面试验成功-MAXII 240cpld and 0-1023.75 development of 6675 degrees C temperature sensor data acquisition system, using seg7 LED shows that the accuracy o
LPC2DDR2
- Module Function Descr iption: This module allows a SPI ROM to be used in a LX/CS5536 system. Details are below: 1.Provide a memory window to the SPI EPROM at FFF80000h-FFFFFFFFh (512KB). 2.Provide an interface to the SPI bus to allow the
spi_master_phy
- 这是spi接口传输的一部分内容，本源码一共三部分，功能：spi接口的的实现即对外设的读写数据-This is the spi interface transfer part of the contents of a total of three parts of this source, function: spi interface that the realization of the read and write data to the peripheral
spi_verilog
- 实现SPI MASTER功能，并有仿真代码和仿真结果。-To achieve SPI MASTER function, and a simulation code and simulation results.
vspi
- 一个用vhdl语言写的spi接口实例，经过altera的fpga测试可以使用。-Written in a language with vhdl spi interface to an instance, after the fpga altera test can be used.
FPGA_SPI.ZIP
- 实现了FPGA以SPI协议传送和接受16位数据。传送过程无需Nios核干预-SPI protocol to achieve the FPGA to send and receive a 16-bit data. Nios nuclear transfer process without intervention
VHD_Veri_spi
- 一个强大的符合SPI规范的VHDL/Verilog源码文件，传输模式和时钟相位均可以指定，采用同步时钟设计，可以工作在很高的频率下。支持主机及从机模式，强烈推荐使用！-A strong line with SPI standard VHDL/Verilog source files, transfer mode, and clock phase are to specify, using synchronous clock design can work in very high frequen
SpiMaster
- This a verilog code for SPI Master testbench is also provided spi_top.v Xilinx ISE or Icarus verilog to compile and simulate-This is a verilog code for SPI Master testbench is also provided spi_top.v Xilinx ISE or Icarus verilog to compile an
VHDL-based-design-of-SPI
- 基于VHDL的串行同步通信SPI设计 本设计是用Quartus作为开发环境，以DE2板为硬件平台实现的SPI同步串行通讯。设计过程方便。根据接收和发送两个主要部分实现了SPI的基本功能。此外，该设计还实现了波特率发生器，数码管显示的功能。用DE2板实现具有电路简洁，开发周期短的优点。充分利用了EDA设计的优点。开发过程用了VHDL硬件描述语言进行描述，从底层设计，分模块进行，充分提高了设计者的数字逻辑设计的概念。-VHDL-based SPI serial synchronous comm
spi
- 描述了总线的vhdl程序，并且有测试语句的描写 仿真之后可以实现-Describes the bus vhdl program, and a test statement, after describing the simulation can be achieved
SPI_FPGAFOLLOW
- FPGA作为从机的SPI模块，VHDL语言编写，quartus2开发-FPGA as a slave SPI module, VHDL language, quartus2 development
SDcard
- 一个能用SPI模式的SD读卡程序(VHDL)-A SD card reader program can use SPI mode (VHDL)
verilog_spi-master
- verilog_spi A simple demo SPI interface implemented in verilog
spiVerilog-master
- spiVerilog A Verilog SPI module