搜索资源列表
timer0_2
- CPLD+MCU电压采集系统 测试程序+原理图\测试程序\定时器\用定时器T0方式1控制LED闪烁-CPLD+ MCU voltage acquisition system Schematic test procedure+ \ Test Programs \ timer \ timer T0 Mode 1 control with LED flash
3
- 本实验的实现功能:利用定时器实现LED闪烁,适用于c51及zigbee开发板-Implementation features of this experiment: the use of timer, LED flash for c51 and zigbee development board
attachments_2011_02_17
- 8031 – No on-chip ROM 8751 – With on-chip EPROM 8052 – 8051 with 128 bytes extra IRAM, extra 16 bit timer, additional SFRs to use the timer Atmel AT89C51 – With on-chip Flash ROM Dallas Semiconductor DS5000 – On-chip NV-RAM and In system prog
SCM-C-language-program-timing
- 利用定时器0工作方式1,在开发板上实现第一个发光二极管以1ms为周期的闪烁。新建文件夹,程序代码如下所示-Timer 0 Mode 1 use of the work in the development of on-board LEDs to achieve the first cycle of 1ms for the flash. New folder, the program code is as follows
MC9S08LG32_source
- MC9S08LG32单片机的源代码,含3种CRC算法,flash模拟EEPROM驱动,串口驱动,GPIO操作,定时器驱动,ADC采样驱动,CD4067驱动,分时复用算法,睡眠模式,等等 公司产品的独特代码已册除,见谅-MC9S08LG32 microcontroller source code, including CRC algorithm 3, flash analog EEPROM driver, serial driver, GPIO operation, the timer-dri
lesson5_3
- 利用动态扫描和定时器1在数码管上显示出从765432开始以1 秒的速度往下递减直至764987并保持显示此数,与此同时利用定时器0以500MS速度进行流水灯从上至下移动,同时蜂鸣器发声,当数码管上数减到停止时,实验板上流水灯全部闪烁5次,数码管全熄灭。单片机进入休眠状态。 -Dynamic scan and Timer 1 on the digital display of 1 from the 765,432 begin to decline until the second speed
jiaotongdeng
- 本交通灯以AT89S51单片机为核心,通过编程可实现使8位发光二极管按照交通灯的模式工作;通过识别按键,可以改变红灯、黄灯等待时间和工作模式;时间的产生通过定时器0计时方式1来实现,确保计时精确。本系统直接模拟直通的十字路口交通灯,初始设定为绿灯亮15s,然后黄灯亮5s,之后开始转换车道。在红灯等待的时间内,通过数码管显示等待时间。到黄灯时,黄灯会闪烁发光给人以提醒要转换车道。当车流量发生变化需要调整时间时,可以通过3个按键中的2个按键加减计时,同时改变后的时间会通过4位发光二极管以二进制模式显
chengshidengguang
- 通过单片机编程实现城市灯光闪烁控制,本装置在使用中,是用到定时器来控制不同的闪烁方式的。当一个完整的闪烁结束后,即可转入新的闪烁方式。-Through the city lights flash microcontroller programming control, the device is in use, the timer is used to control the different flash modes. When after a complete blink, flicker
ADC_voice-signal-capture
- 利用定时器触发ADC采集语音信号,存储到FLASH中,读回后用SPWM输出,经过低通滤波后可以还原出原始信号波形,效果还不错-Use a timer to trigger the ADC capture the voice signal stored in the FLASH, read back with SPWM output after low-pass filtering can restore the original signal waveform, the results were
TC
- ARM定时器闪灯程序,at91sam7a3-ARM timer flash program, at91sam7a3
MSP430-foundation-program-summary
- MSP430基础程序汇总,包括:I/O端口、基础时钟模块、TimerA/B、UART、看门狗定时器、比较器、FLASH、ADC等-MSP430-based summary of the program, including: I/O ports, the basic clock module, TimerA/B, UART, watchdog timer, comparators, FLASH, ADC, etc.
1011
- 力天 arm210X源码程序(共19个例程)包括闪灯、看门狗、定时器、pwm、串口、数码管、12864液晶驱动-Litian arm210X source program (a total of 19 routines), including Flash, Watchdog timer, pwm, serial, digital, LCD driver 12864
MSP430danpianjiCprogramingdesign
- 实用的基础msp430的模块程序C语言编程 包括基础时钟,ADC,DAC单通道单序列,多通道多序列等,锁相环,异步串行,,FLASH擦写,中断,比较捕获,PWM波形的产生,LCD模块程序,行列式键盘,基本定时器,DMA数据传输捕获脉冲信号周期等-Practical basis for msp430 module C programming, including basic clock, ADC, DAC channel single sequence, such as multi-chann
int
- 对定时器0采用中断方式编程的方法,实现闪灯程序。C51源程序,简洁易懂,适用初学者。-The timer 0 interrupt programming methods used to achieve the flash program. C51 source, simple and easy to understand for beginners.
LedDemoProgram_Based-on-Intterupt
- 利用定时器0中断完成的1S定时闪灯演示实验-Timer 0 interrupt done using regular flash demonstration experiment 1S
TMS320X281xDSP_DEMO
- 本光盘包含的应用程序如下: Test1 C语言编程 Test2 硬件测试 Test3 GPIO应用 Test4 定时器应用 Test5 ADC应用 Test6 SPI接口应用 SPI接口DAC(SPI_DAC5617) SPI_DAC_ADC SPI存储器扩展(SPI_EEPROM) Test7 SCI应用 中断模式(SCI_interrupt) 状态查询模式
EX02_CpuTimer2
- DSP2812定时器LED验证显示源程序,LED会奇偶数交替闪烁-DSP2812 timer LED display source code verification, LED will flash alternately odd number
LED
- 单片机定时器控制LED灯的闪烁,能帮助学习定时器的应用-Single-chip timer controls the LED lights flash, application of the timer can help learning
CPUTimer
- 包括TMS320F2812的定时器程序,分为含DSPBIOS和不含DSPBIOS,以及FLASH和RAM版本。-Including TMS320F2812 timer program, divided into with DSPBIOS and without DSPBIOS, and FLASH and RAM versions.
led
- 有关流水灯的不同的变化的程序,1)间隔300ms先奇数亮再偶数亮, 循环三次;一个灯上下循环三次; 两个分别从两边往中间流动三次; 再从中间往两边流动三次;8个全部闪烁3次; 关闭发光管,程序停止。 2)上下下上两次,全熄全亮五次 3)演示8位二进制数累加过程 4)依次亮一下 5)流水灯+蜂鸣 6)流水灯+定时器-Different light on the changes in water programs, 1) interval of 300ms the