搜索资源列表
4bitSM
- spaital modulation技术相比于v-blast,mrc等方式有了长足的进步。4bit/s/Hz频谱利用率下的空间调制程序，利用BPSK,4QAM和8QAM调制方式。-spaital modulation technique compared to the v-blast, mrc, etc. has made substantial progress. 4bit/s/Hz spatial modulation spectrum utilization under the progr
V-BLAST
- 分层空时编码技术是提高无线信道传输速率和容量的一种非常有效的方法。在无需提高信号发射功率和额外增加带宽的情况下就可以大幅度的提高系统容量。但是，分层空时编码无法获得最大分集增益，所以接收端在恢复信号时选用的译码算法对系统性能至关重要。-Layered space-time coding technology is to improve the wireless channel transmission rate and capacity of a very effective method. W
zf
- v-blast结构的迫零检测 无干扰消除和理想干扰消除对比-v-blast ZF
vblast
- V-BLAST空时码仿真，干扰消除和无干扰消除的SNR-FER曲线-Simulation of V-BLAST
VBLAST
- In this simulation, a 2 x 2 MIMO system with BPSK modulation is used. Then, the algorithm of V-BLAST is implemented. After that, weight vector is produced using ZF, MMSE and ML detectors. Finally, the BER performance is plotted. A flat fading Rayleig
MMSE
- 基于V-BLAST 的MMSE 信道估计算法 MIMO-The MMSE channel estimation algorithm based on V- BLAST MIMO
ZF
- The ZF channel estimation algorithm based on V - BLAST MIMO -The ZF channel estimation algorithm based on V- BLAST MIMO
tp2_program
- 用Matlab仿真一个发端4天线，收端6天线的V-BLAST系统.接收端分别使用ZF（迫零），MMSE（最小均方误差），ML（最大似然）和SIC（串行干扰消除）算法，分析比较各个算法下的误比特率。-Matlab simulation of an originator with 4 antennas, antenna receiving end 6 V-BLAST system. Receiving end were using ZF (zero forcing), MMSE (minimum m
VBLAST
- In this simulation, a 2 x 2 MIMO system with BPSK modulation is used. Then, the algorithm of V-BLAST is implemented. After that, weight vector is produced using ZF, MMSE and ML detectors. Finally, the BER performance is plotted. A flat fading Rayleig
generalised.RAR
- Abstract—A generalised spatial modulation (SM) scheme with multiple active transmit antennas, named as multiple activespatial modulation (MA-SM), is proposed in this paper. By allowing multiple transmitting antennas in the SM system to transmit
ex3
- V-BLAST结构的ZF检测算法性能，分别在无干扰消除和有干扰消除的系统性能-ZF detection algorithm performance V-BLAST structure, respectively, and there is no interference to eliminate interference cancellation system performance
VBLAST
- In this simulation, a 2 x 2 MIMO system with BPSK modulation is used. Then, the algorithm of V-BLAST is implemented. After that, weight vector is produced using ZF, MMSE and ML detectors. Finally, the BER performance is plotted. A flat fading Rayleig
detection
- MIMO系统V-BLAST结构关于BER的仿真，发送符号为QPSK信号，采用ZF,QR，MMSE,ML解调技术-MIMO system V-BLAST structure simulation on BER, transmission symbol is QPSK signal, using ZF, QR, MMSE, ML demodulation techniques
vblastpic11
- v-blast系统的检测方法，即并行干扰消除检测方法-Detection v-blast system, ie parallel interference cancellation detection method
ITPP-ZF_VB_DFE-4_4-4QAM
- 基于IT++的MIMO下行链路采用V-BLAST的ZF-DFE（ZF-VB DFE）检测算法采用4QAM调制-MIMO ZF-DFE detection algorithm using V-BLAST (ZF-VB DFE) based IT++ using 4QAM modulation
MIMO
- mimo无线通信Alamouti方案，重复码编码方案，迫零接收及匹配接收方案实现的matlab源程序 -Implement a complete MIMO system with different combinations of the following components: (a) Alamouti, repetition code, and V-BLAST (at the transmitter) (b) zero-forcing and MMSE (at the rec
QR
- 该程序是基于QR分解的V-BLAST检测算法,两种算法，包括QR分解算法和SQRD算法。-The program is based on QR decomposition V-BLAST detection algorithm, two algorithms, including QR decomposition algorithm and SQRD algorithm.
vblastZF
- Matlab Code for capacity of a MIMO channel using V-BLAST algorithm.
MUMP_3U3P_S_3P_ZF
- 此程序是针对在V-BLAST结构下的ZF检测算法而编写的，能够直观看到ZF检测算法的性能(This program is for the V-BLAST structure under the ZF detection algorithm and prepared to be able to see the performance of ZF detection algorithm)
modej
- 本程序是对V-BLAST系统及其检测算法的仿真,可采用BPSK,QPSK,16QAM,64QAM调制,检测算法为ML,MM()