搜索资源列表
SPWM_totry3
- DSP2812产生SPWM正弦信号， 用示波器观察PWM1~PWM6（J12的13～18脚）引脚输出的波形-DSP2812 generate SPWM sine signal with an oscilloscope PWM1 ~ PWM6 (J12 13 ~ 18 feet) waveform output pin
Simple_digital_oscillograph
- AVR,mega16单片机写的简易示波器程序-avr mcu内容
DS0201V1.1
- 经济型袖珍示波器DS0201V1.1版硬件中的全套源程序-Pocket Oscilloscope DS0201V1.1 economical version of the full source hardware
epwm_trip_zone07-30
- dsp280x实现输出四路PWM波形，可以改变波形的周期和占空比，输出波形的相位也不同，在示波器上能看到波形，代码全部调试合格，ccs3.1下编译通过- This program requires the DSP280x header files. // // Initially tie TZ1 (GPIO12) and TZ2 (GPIO13) high. // // During the test, monitor ePWM1 or ePWM2 outpu
MC8051_IPcore
- 利用FPGA开发一个示波器源码程序，欢迎各位多多下载参考-FPGA development using an oscilloscope source program..
MeasurementLibrary_1
- ppy_SP_1:利用NI示波器实现频谱仪的功能-ppy_SP_1: NI oscilloscope spectrum analyzer using the function
SaveToFile
- 示波器采集数据实现保存成数据文件，比较好用-Oscilloscope data acquisition to achieve preservation of data
Scope_SP
- Scope示波器采集多用数据，并进行数据处理，最终得到结果，对示波器变成很有参考意义-Scope Oscilloscope multi-purpose data acquisition and data processing, result end up on the oscilloscope into a lot of reference value
oscillograph_AVR
- 通过这个示波器的制作，你将会了解很多东西，比如如何运用运算放大器组合放大电路，高速AD转换器的应用、FIFO存储器的应用、AVR单片机SPI总线接口协议以及点阵液晶驱动。-Produced by the oscilloscope, you will understand many things, such as how to use the combination of amplifier op-amp, high-speed AD converter application, FIFO mem
DSOTeckic
- 数字存储示波器的组成以及测试中需要注意的地方，经典资料，适合初学者。-The composition of digital storage oscilloscope and test areas that need attention, classical information, suitable for beginners.
QuXian
- 非常好的绘制曲线工具，类似示波器，实现了对绘制方法封装，容易调用-Very good tool for drawing curves, similar to the oscilloscope
wave_shown
- 基于飞利浦的单片机P89V51以及LCD屏RT12864的简易示波器程序；-Based on Philips microcontroller and LCD screen RT12864 P89V51 simple oscilloscope procedures
tds2014b
- 这是用labwindows/CVI 8.5开发的一个示波器，里面有例程，我总觉得它比labview开发性要强-This is labwindows/CVI 8.5 development of an oscilloscope, which has routines, I feel stronger than the labview development
avr
- 用avr做的数字示波器，四个按键可调控频率和幅值。-Avr to do with the digital oscilloscope, the four buttons can control the frequency and amplitude.
da5620
- da5620调试程序：用单片机控制da的输出脚和放大倍数。然后用数字示波器测输出管脚的波形，读出电压值-da5620 debugger: The output of SCM da feet and magnification. Then measured with digital oscilloscope waveform of the output pins, read voltage
SCIControlTest
- 该程序实现了利用串口发送命令来控制下位机电机转速的监控界面。该界面利用MFC编写，开发环境为VS2008。界面上有一个转速示波器分别显示给定转速和实际转速。并且示波器大小和比例尺还会随着窗口的变化而变化。 其下位机程序为SCIControlTest_DSP-This program implements the control interface of moter speed via serial port. And the interface was programed with MFC
Henry
- 基于CVI的虚拟模拟示波器，适用于专业实习之类的。-CVI-based virtual analog oscilloscope, for the professional practice of the class.
WAVE
- 读取wav 波形图，类似于示波器，使用c++ 编程-Read wav waveform
Digital_oscilloscope_VHDL
- 利用VHDL语言编写数字示波器的程序，下载入FPGA中可实现。在Quartus7.1编译环境中已经测试通过。-Digital oscilloscope using VHDL language program, download into the FPGA can be achieved. In Quartus7.1 build environment has been tested.