搜索资源列表
dsPIC33FJ128GP706_2011_0611
- dsPIC33FJ128GP706 这个芯片的测试程序,主要实现IO口设置、AD设置、定时器设置、液晶控制、RS232设置、I2C总线传输模式等方法。-dsPIC33FJ128GP706,the chip testing procedures, the main achievement of the IO port settings, AD settings, timer settings, LCD control, RS232 set, I2C bus transfer mode and ot
TPA81_pic24f
- 我已经得到了相当多的要求与I2C总线部分的PIC24教程。-I’ve gotten quite a few requests for the I2C bus section of the PIC24 tutorial. PIC I2C
LPC900_SPI
- LPC900 FLASH单片机,是PHILIPS公司推出的一款高性能、微功耗51内核单片机,主要集成了字节方式的I2C总线、SPI总线、增强型UART接口、实时时钟、E2PROM、A/D转换器、ISP/IAP在线编程和远程编程方式等一系列有特色的功能部件。-LPC900 FLASH MCU is PHILIPS company introduced a high performance, micro-power 51-core chip, a byte-oriented major integr
I2C_v
- 本工程主要是介绍操作一个I2C总线接口的EEPROM AT24C08的方法,使用户了解I2C总线协议和读写方法。 2、通过JTAG口把I2C_FPGA.sof下载到FPGA后,请先长按reset按键大约1秒左右,以进行初始化。按一下实验板上的KEY1键,计数器加1计算,并把计算结果写入EEPROM,并同时显示在数码管最低位,按KEY0把EEPROM的数据读取出来,并显示在数码管上。-Operation of this project is to introduce an I2C bus inte
AT24C512
- I2C总线的驱动程序,应用于AT24C64到AT24C512芯片上-I2C bus driver, applied to the AT24C512 chip AT24C64
I2C
- 这是avr单片机iic总线的程序,很好很实用,总线是必须好好弄一下的,在此献给大家-This is iic bus microcontroller avr program, very very practical, the bus must get a good look, and dedicated to everyone in this
ADS1100
- 很实用的16位AD芯片,差分输入,I2C总线,使用简单-Very useful 16-bit AD-chip, differential input, I2C bus, using a simple
mcp3221
- 既便宜又实用的12位AD芯片,差分输入,I2C总线,使用简单-Cheap and practical 12-bit AD chips, differential input, I2C bus, using a simple
IIC
- 利用单片机IDE软件实现对I2C总线器件操作,包括AT24C01,PCF8563,LM75,PCF8574-The use of SCM software IDE devices on the I2C bus operations, including AT24C01, PCF8563, LM75, PCF8574
I2C
- 基于LYS-51开发板的IIC总线驱动,包括读字节,写字节,开始,停止,应答函数。可用于驱动IIC总线上的设备。-LYS-51 development board based on the IIC bus driver, including read-byte, write byte, start, stop, response function. Can be used to drive the device on the IIC bus.
Allfun-code
- 基于51单片机进行组态,包括温度的检测,电机驱动,i2c总线操作等程序-Based on 51 single-chip configuration, including temperature detection, motor drive, i2c bus operations and other procedures
SimIIC
- 通用I2C总线模似程序,带延时功能,以适用不同速度的单片机。-Generic I2C bus mode similar procedures, with a delay function to apply a different speed microcontroller.
WinCE_I2C_E_GPS
- :在某型军车的“姿态测量与数据存储系统”设计中,为实现嵌入式微处理器对数字罗盘集成电路HMC5843 的数据的采集,需开发运行于WinCE操作系统下的I2C驱动程序。文章首先论述了ARM9微处理器与HCM5843的 连接关系,随后论述了I2C总线的概念、工作原理与WinCE的流驱动模型等基本知识,最后以Platform Builder 5.0为 开发工具,开发了I2C驱动程序,并主要从中断服务线程IST与读函数IIC Read两个方面,介绍了驱动程序的具体实 现。实验表明,该驱动
I2C_C51
- I2C总线驱动代码!采用KEIL编译,采用语言为C51-I2C bus driver code! Using KEIL compiler, using the language for the C51
2410_I2C
- FS2410开发板I2C驱动程序,对了解学习I2C总线有帮助-FS2410 development board I2C driver
verilog
- i2c总线控制协议,一共五个v文件。没有加外部io-i2c bus control protocol, a total of five v file. No additional external io
pca9698_gpio
- PCA9698是I2C总线的IO口扩展芯片。这是其linux 2.6.28下的驱动程序。-PCA9698 I2C bus is the expansion of the IO port chip. This is the driver under linux 2.6.28.
mimasuo
- 密码锁,EEPROM与单片机之间采用I2C总线通信,保证密码掉电不丢失。-Lock, EEPROM using I2C bus between the microcontroller communication, non-volatile to ensure that password.
98-24c02
- 24C02源程序代码,采用I2C总线与单片机交互。-24C02 source code, interact with the microcontroller using the I2C bus.
Codec
- 用来控制codec器件工作 程序的主要内容是: 1、配置I2C总线控制codec的工作模式。 2、配置McBSP1,接收与发送codec的数据。-Procedures used to control the codec device main contents are: 1, I2C bus control the codec configuration mode. 2, configuration McBSP1, data reception and transmission co