搜索资源列表
DSPsourcecode
- codec－－－录音回放实验 CpuTimer－－TIMER0定时器实验 EXRAM－－扩展RAM读写实验 led_flash－－LED灯闪实验 McBSP－－MCBSP接口的立体声警报实验 TCPIP－－TCP/IP，UDP实验，网卡发送接收实验 wavDEMO－－歌曲播放实验，AIC23播音实验 mp3demo－－MP3播放实验（适用于mp3网络语音开发板） -audio playback codec--- exper
fpgaexperiment
- 总共包括7个实验，SRRAM测试，按键及PIO口中断实验，定时器实验，seg7实验，sopc_led实验，FLASH少些，FPGA_led,锁相环。-Including a total of 7 experiments, SRRAM test, test buttons and PIO port interrupt, timer experiment, seg7 experiment, sopc_led experiment, FLASH less, FPGA_led, PLL.
SEED-DEC6713
- 合众达SEED-DEC6713源码，包括Timer，Uar，Usb，Flash，Gpio，uboot，edma等内容-Triangle of SEED-DEC6713 source, including Timer, Uar, Usb, Flash, Gpio, uboot, edma etc.
Play_WAVE
- MSP430 应用源程序。 包括： GPIO Flash Memory P1 Interrupt Timer A UART I2C PWM Playing Music Huminity Sensor Pressure Sensor LCD_2X12 LCD240X160 Speaking LM75A DS2401 IR_Decoder 可以到http://franktu.com/下载更多源程序。-MSP430
led
- 基于TMS320VC5416的定时器编程，DSP工作在8MHZ主频，定时器分频系数为15，通过DSP通用I/O引脚控制指示灯闪烁，指示灯每秒闪烁1次。-TMS320VC5416 timer based programming, DSP working in 8MHZ frequency, the timer frequency factor of 15, through the general-purpose DSP I/O pin control light is blinking, the
em78f662n
- 义隆 flash 662 各个功能的dome程序，包括定时器，睡眠唤醒，tcc，以及ad，eeprom的样例。-Elan dome of each function flash 662 procedures, including the timer, sleep wake, tcc, and the ad, eeprom sample.
timer0_2
- CPLD+MCU电压采集系统 测试程序+原理图\测试程序\定时器\用定时器T0方式1控制LED闪烁-CPLD+ MCU voltage acquisition system Schematic test procedure+ \ Test Programs \ timer \ timer T0 Mode 1 control with LED flash
3
- 本实验的实现功能：利用定时器实现LED闪烁，适用于c51及zigbee开发板-Implementation features of this experiment: the use of timer, LED flash for c51 and zigbee development board
attachments_2011_02_17
- 8031 – No on-chip ROM 8751 – With on-chip EPROM 8052 – 8051 with 128 bytes extra IRAM, extra 16 bit timer, additional SFRs to use the timer Atmel AT89C51 – With on-chip Flash ROM Dallas Semiconductor DS5000 – On-chip NV-RAM and In system prog
SCM-C-language-program-timing
- 利用定时器0工作方式1，在开发板上实现第一个发光二极管以1ms为周期的闪烁。新建文件夹，程序代码如下所示-Timer 0 Mode 1 use of the work in the development of on-board LEDs to achieve the first cycle of 1ms for the flash. New folder, the program code is as follows
MC9S08LG32_source
- MC9S08LG32单片机的源代码,含3种CRC算法,flash模拟EEPROM驱动,串口驱动,GPIO操作,定时器驱动,ADC采样驱动,CD4067驱动,分时复用算法,睡眠模式,等等 公司产品的独特代码已册除,见谅-MC9S08LG32 microcontroller source code, including CRC algorithm 3, flash analog EEPROM driver, serial driver, GPIO operation, the timer-dri
lesson5_3
- 利用动态扫描和定时器1在数码管上显示出从765432开始以1 秒的速度往下递减直至764987并保持显示此数，与此同时利用定时器0以500MS速度进行流水灯从上至下移动，同时蜂鸣器发声，当数码管上数减到停止时，实验板上流水灯全部闪烁5次，数码管全熄灭。单片机进入休眠状态。 -Dynamic scan and Timer 1 on the digital display of 1 from the 765,432 begin to decline until the second speed
jiaotongdeng
- 本交通灯以AT89S51单片机为核心，通过编程可实现使8位发光二极管按照交通灯的模式工作；通过识别按键，可以改变红灯、黄灯等待时间和工作模式；时间的产生通过定时器0计时方式1来实现，确保计时精确。本系统直接模拟直通的十字路口交通灯，初始设定为绿灯亮15s，然后黄灯亮5s,之后开始转换车道。在红灯等待的时间内，通过数码管显示等待时间。到黄灯时，黄灯会闪烁发光给人以提醒要转换车道。当车流量发生变化需要调整时间时，可以通过3个按键中的2个按键加减计时，同时改变后的时间会通过4位发光二极管以二进制模式显
chengshidengguang
- 通过单片机编程实现城市灯光闪烁控制，本装置在使用中，是用到定时器来控制不同的闪烁方式的。当一个完整的闪烁结束后，即可转入新的闪烁方式。-Through the city lights flash microcontroller programming control, the device is in use, the timer is used to control the different flash modes. When after a complete blink, flicker
ADC_voice-signal-capture
- 利用定时器触发ADC采集语音信号，存储到FLASH中，读回后用SPWM输出，经过低通滤波后可以还原出原始信号波形，效果还不错-Use a timer to trigger the ADC capture the voice signal stored in the FLASH, read back with SPWM output after low-pass filtering can restore the original signal waveform, the results were
TC
- ARM定时器闪灯程序，at91sam7a3-ARM timer flash program, at91sam7a3
MSP430-foundation-program-summary
- MSP430基础程序汇总，包括：I/O端口、基础时钟模块、TimerA/B、UART、看门狗定时器、比较器、FLASH、ADC等-MSP430-based summary of the program, including: I/O ports, the basic clock module, TimerA/B, UART, watchdog timer, comparators, FLASH, ADC, etc.
1011
- 力天 arm210X源码程序(共19个例程)包括闪灯、看门狗、定时器、pwm、串口、数码管、12864液晶驱动-Litian arm210X source program (a total of 19 routines), including Flash, Watchdog timer, pwm, serial, digital, LCD driver 12864
MSP430danpianjiCprogramingdesign
- 实用的基础msp430的模块程序C语言编程 包括基础时钟，ADC,DAC单通道单序列，多通道多序列等，锁相环，异步串行，，FLASH擦写，中断，比较捕获，PWM波形的产生，LCD模块程序，行列式键盘，基本定时器，DMA数据传输捕获脉冲信号周期等-Practical basis for msp430 module C programming, including basic clock, ADC, DAC channel single sequence, such as multi-chann
int
- 对定时器0采用中断方式编程的方法，实现闪灯程序。C51源程序，简洁易懂，适用初学者。-The timer 0 interrupt programming methods used to achieve the flash program. C51 source, simple and easy to understand for beginners.