搜索资源列表
linux-pwm
- 基于嵌入式Linux下的PWM控制蜂鸣器测试程序(包括源代码以及makefile)-Embedded Linux-based PWM control buzzer under the test program (including source code and makefile)
Test
- 为44B0的测试代码,可以测试蜂鸣器,IIS 播放WAV文件,USB点灯,按键,串行FLASH,IDE硬盘 LCD等。 0 : Please input a number 1 : Memory test 2 : Timer PWM test ( Beep ) 3 : IIC EEPROM test 4 : ADC test 5 : Download File by uart(DNW) 6 : IIS Play test(Please download *.wav by
PWM
- 430 PWM波形程序 在430板子上测试成功 能真确运行-430 430 PWM waveforms on the board in the test program can actually run a successful
test
- 小车循迹控制,通过pwm波控制车速,且能在到达1分钟时是小车停止运作-Car tracking control, controlled by pwm wave speed, and can reach 1 minute in the car when they stop working
pwm
- mini2440 的驱动测试代码,包括c文件和Makefile-mini2440 appication program for test pwm module.
PWM
- 2440测试程序pwm在ADS1.2环境下编译-2440 pwm test program compiled under the ADS1.2
2812-PWM
- 2812 PWM 测试程序 亲测有效-2812 PWM test program effective pro-test! ! ! !
PWM
- 基于ATMEGA128单片机的6路SPWM输出测试程序,开发平台为AVR STUDIO4.17,已通过PROTEUS7.7仿真软件测试。-ATMEGA128 microcontroller-based 6-channel SPWM output test program, the development platform for the AVR STUDIO4.17, simulation software has been tested by PROTEUS7.7.
PWM--test-program
- 完成8051F310的配置以后,可以通过此程序完成PWM的测试程序。-8051F310 completed the configuration later, this procedure can be done by PWM of the test program.
pwm
- arm cm3 lm3s9b96教学开发板pwm输出测试程序-arm cm3 lm3s9b96 teaching pwm output test program development board
PWM
- PWM TEST PROGRAM FOR S3C2440 RUNNING WINCE
PWM
- STC12C5A系列单片机PWM测试程序。用一参数设置脉冲宽度,数越大,低脉冲越大。已通过。-STC12C5A MCU PWM test program. Parameter settings with a pulse width, the greater the number, the greater the low pulse. Has passed.
PWM
- 内容:1、利用定时器产生PWM,了解原理和使用方法 2、硬件要求:LED灯 定时器 3、试验现象:LED灯由亮到灭,由灭到亮逐步变化,也就是调光现象-: 1, using the timer generates PWM, understand the principle and the use of method 2, the hardware requirements: LED light timer 3, the test phenomenon: LED light from b
PWM
- Linux下的S3C2440的PWM测试测序,仅供参考学习-S3C2440 under Linux the PWM test sequencing for reference purposes only learning
test-pwm
- FPGA 生成PMW波及其测试程序 使用modelsim se版本10.0测试可用-The FPGA generates the PMW wave and its test program
PIC16F877-PWM-Code
- TEST PWM IN PIC 16F877 MICROCHIP
PWM输出实验
- 通过数据手册对单片机的IO口进行PWM测试,首先该IO口要有时钟信号,然后再程序中设置频率,即可以看到呼吸灯;也可用示波器测试,得到方波。(Through the data manual, PWM test on the IO port of the microcontroller, first of all, the IO port to have a clock signal, and then set the frequency in the program, that is, you c
PWM
- 通过设置时钟实现脉冲宽度调制的verilog代码及测试(By setting the clock to achieve pulse width modulation of the Verilog code and test)
3、PWM输出实验
- 小车程序的pwm测试程序,嵌入式小车程序底层Pwm电机驱动(PWM test procedures for car procedures)
STM19定时器输出4路PWM波可调占空比
- STM32定时器输出四路可调PWM波,经测试可以实现。(STM32 timer output four adjustable PWM wave, the test can be achieved.)