搜索资源列表
CFO_Correction
- 载波频率同步Verilog程序 基于xilinx ise 实现-Carrier frequency synchronization Verilog program is based on xilinx ise to achieve
CC1110_CSMA
- 附件内文件功能是利用TI公司的CC1110单片机实现点对多点载波监听CSMA。程序在IAR7.2软件平台下编译通过,可以在CC1110单片机中正常下载运行。-Within the file attachment feature is the use of TI s CC1110 MCU-to-multipoint Carrier Sense CSMA. Under the program compiled by IAR7.2 software platform, you can download
hdb
- 数字基带信号的传输是数字通信系统的重要组成部分。在数字通信中,有些场合可不经过载波调制和解调过程,而对基带信号进行直接传输。采用AMI码的信号交替反转,有可能出现四连零现象,这不利于接收端的定时信号提取。而HDB3码因其无直流成份、低频成份少和连0个数最多不超过三个等特点,而对定时信号的恢复十分有利,并已成为CCITT协会推荐使用的基带传输码型之一。为此,本文利用VHDL语言对数据传输系统中的HDB3编码器进行了设计。 基于达到达到达到的信号发生器的源程序-Digital baseband
20081224
- 文件列表
DXB
- 福星小程单相电能表载波通信模块结构要求V1.0-Fuxing small range of single-phase energy meter-carrier communication module structure requires V1.0
carrier
- 载波集抄的模块收,转的完整程序,可灵活根据协议配置相关的模块-this is important the electri program.
programe
- 红外通讯和485远程通讯,通过红外载波实现无线通讯,hl6024对nec9234的显示驱动程序,按键扫描程序。-485 infrared communications and telecommunications, wireless communications through infrared carrier wave, hl6024 on nec9234 display driver, key scanner.
PL3106chipmanual
- PL3106芯片手册v1.1载波通信接收电路设计程序低压电力线载波-PL3106 chip Manual v1.1 carrier communication receiver circuit design program in power line carrier
wuxiantongxin
- 此无线通信程序具有极大的发挥性,可以自由修改符合自己的通信编码要求,编码与解码均为自编,配以射频载波即可实现无线通信与控制。-The wireless communication program of great play, and it can freely modify the code consistent with their communication requirements, both encoding and decoding self, together with the RF
FM
- 本设计根据锁相环原理,通过两片CD4046搭接基本电路来实现FM调制/解调电路的设计,将调制电路的输出信号作为解调电路的输入信号,最终实现信号的调制解调。原理分析,我们得到的载波信号的电压 大于3V,最大频率偏移 5KHz,解调电路输出的FM调制信号的电压 大于200mV可以看出我们的具体设计符合设计指标。-FM
SPWM_ASM
- 使用汇编语言要生成PWM,通过设定基波频率,载波频率,最大分辨率参数生成点数步进角度(弧度)等,生成在相PWM表的一个软件-Using assembly language to generate PWM, by setting fundamental frequency, carrier frequency, the maximum resolution parameter generation step angle points (in radians), etc., generated in
SPWM_C
- 使用C语言生成WPWM所需要的正弦抽样值,通过设定基波频率,载波频率,最大分辨率,每行点数,控制点数来生成SPWM表格-Using the C language generation WPWM need sine sample value, by setting the fundamental wave frequency, carrier frequency, maximum resolution, each line of points, control points to generate
generate_SPWM
- 载波频率15627.77Hz,产生脉宽调制的波形,用mega161写的程序-Carrier frequency 15627.77Hz, generate PWM waveforms, with written procedures mega161
pl3200DEMO
- 载波通讯源码,可实现集中抄表,支持多级采集器的级连;-Carrier communication source, enabling automatic meter reading, to support multi-collector cascade
Irdata_data_ok
- 基于NEC单片机的红外发射程序,用定时器H1产生载波,定时器51控制编码0和1的高低电平宽度。-NEC MCU based on infrared emission process, with the timer H1 carrier generated, the timer 51 control codes 0 and 1, the width of high and low.
1
- msp430 逆变,单相逆变,载波20kHz,调制波50Hz,-Inverter, single-phase inverter, carrier 20kHz, modulation wave 50Hz,
081701
- msp430,单相逆变,载波20kHz,调制波50Hz-msp430, single-phase inverter, carrier 20kHz, modulation wave 50Hz
sinewave_FPGA
- 数字载波发生器,产生一个正弦波,工程中的所有模块都经过测试并运行没有任何问题,而且利用逻辑分析仪对每个模块的输出都进行了逻辑测试。并经过D/A转换得到了正弦波波形,但唯一的缺点是没有滤波器,如果有人想看标准正弦波,可以自制一个简易低通滤波器进行观看,如有不清楚的地方可以把问题发到我的邮箱jiangguoqian@126.com一起探讨研究。-sinewave
3105
- pl3105载波通讯源程序代码,实现485载波数据交换-pl3105 source code carrier communication, data exchange carrier to achieve 485
pl3201
- 基于RS485通讯的pl3201的和单片机的载波通讯源代码-Pl3201 based on RS485 communication and microcontroller source code carrier communication