搜索资源列表
eeprom_test
- STC89C52的EEPROM测试程序, 你能把它作为一个eeprom的驱动程序来使用-It is the test program of STC89C52 s EEPROM!you can use it as a eeprom driver program!
EPRAM
- EEPROM,.c,.h已封装好,选用STC89c52单片机-EEPROM,. C,. H is a good package, use STC89c52 microcontroller
C
- 硫酸铜建浴设备控制系统 1.按下 P3.4和P3.5不放 按下 P3.7 即可进入设置模式,再次按下退出设置模式 左边四位数码管最左边的开始闪烁,后面的四位数码管不属于此控制系统按下加或减 有 A b C 三档 分别代表三个参数。第一个参数(A):搅拌机运行时间第二个参数(b):液位信号保持时间第三个参数(C): 为定义 各参数保存在STC89C52单片机的内部EEPROM中-Copper sulfate bath construction equipment control system
IIC-AT24C02
- 基于STC89C52单片机,自己编写的EEPROM驱动程序,软件模拟IIC读取。-Based on STC89C52, the EEPROM write their own drivers, software simulation IIC read.
TEA576_FM
- TEA5767采用I2C或者三线接口控制,我是用的I2C,单片机用STC89C52,带1K EEPROM,可以掉电存台,1602LCD显示.-TEA5767 I2C or three-wire interface control, I used the I2C microcontroller STC89C52 with 1K the EEPROM, you can power down the storage units, 1602LCD display.
stc89_eeprom
- stc89c52单片机内部自带的eeprom驱动程序,包含擦除,写入,读出三个子函数-MCU internal stc89c52 comes eeprom driver, including erase, write, read three subfunction
C
- 硫酸铜建浴设备控制系统 * 1.按下 P3.4和P3.5不放 按下 P3.7 即可进入设置模式,再次按下退出设置模式左边四位数码管最左边的开始闪烁,后面的四位数码管不属于此控制系统 按下加或减 有 A b C 三档 分别代表三个参数。 第一个参数(A):搅拌机运行时间 第二个参数(b):液位信号保持时间 第三个参数(C): 为定义 各参数保存在STC89C52单片机的内部EEPROM中-Copper sulfate bath equipment in the
AT24C02
- 基于STC89C52单片机的AT24C02 eeprom程序-Based STC89C52 SCM AT24C02 eeprom program
STCMCUEEPROM
- 使用STC内部DATAROM作为EEPROM记录开机次数,以一位共阳八段数码管显示。晶振频率为12MHZ。型号为STC89C52-To achieve the display boot times using STC MCU internal EEPROM