搜索资源列表
ucoslpc2210gpio
- armlpc2210操作系统ucos-ii下GPIO的例程-armlpc2210 operating system CENTER-ii GPIO under the routines
gpio
- easy arm2210下GPIO的例子,主要说明如何使用GPIO
SAM7X256-GPIO-RSTC-ADS1.2
- at91sam7x256的GPIO已经编译好，GOOD，下载了要给电说明哦
GPIO
- KEIL环境下的ARM程序，基于LPC214x平台。GPIO设置。
uCOS-II-examples-for-ARM7
- uCOS-II应用举例，列举了ARM7处理器下uCOS-II的移植，以及uCOS-II对外围设备的访问（包括gpio、i2c、modem、ppp、pwm、rtc、spi、timer、uart、zlg7290）。-uCOS-II Application Examples, listed under the ARM7 processor uCOS-II of transplantation, and uCOS-II s visit to the peripherals (including gpio
uCOS-II_example.rar
- uCOS移植后的一些应用举例：gpio、pwm、modem、i2c、ppp、spi、uart等,uCOS transplanted some applications, for example: gpio, pwm, modem, i2c, ppp, spi, uart, etc.
LPC1768_Example
- LPC1768基于ucos下例程，包括GPIO，DMA，Modbus等模块-LPC1768-based ucos routines, including GPIO, DMA, Modbus module
ucos-test
- 基于UCOS-II的基础实验，包括GPIO,定时器，PWM，RTC，信号量。和大家分享！-UCOS-II based on the basis of experiments, including GPIO, timers, PWM, RTC, semaphores. To share!
GPIO
- 这是在LPC2210芯片基于UCOS2环境下，GPIO口的应用源代码-This is based on the LPC2210 chip UCOS2 environment, GPIO port the application source code
LPC2148_GPIO
- LPC2148平台下实现GPIO（通用编程I/O），在IAR环境下编译通过。-Under LPC2148 platform GPIO (general-purpose programmable I/O), in the IAR compiler through the environment.
UCOS_for_ARM
- 基于UCOS-II操作系统，在ARM7上实现GPIO和SPI的设计。所上传的为完整的工程。-UCOS-II-based operating system, in the ARM7 to achieve the design of GPIO and SPI.
clockkeyrs232
- 基于ARM和proteus 采用定时器实现秒级定时 2个按键进行时间调整，一个采用中断方式、一个采用GPIO方式实现 显示1采用6个数码管（可带外部驱动器），使用动态扫描方式 显示2采用PROTEUS提供的RS232串口终端，用软件驱动串口进行显示 -Seconds using the timer class from time to time to achieve two key time to adjust to a disruption of the way the u
GPIO
- 2103GPIO程序很有用的，初学者的宝典-gpio for 2103
GPIO
- SmartARM3250开发平台GPIO ucos源码-SmartARM3250 source development platform GPIO ucos
GPIO
- 嵌入式实验代码，GPIO接口编程实验代码-Embedded test code, GPIO interface programming experiment code
GPIO
- GPIO简介每个IO口可以自由编程，单IO口寄存器必须要按32位字被访问-GPIO introduction each IO mouth can freely programmable, single IO mouth registers must be accessed by 32-bit character
GPIO
- ucos2 系统下的GPIO实验 代码c代码!-ucos2 system drivce! gpio
GPIO
- ucos下 ARM7，LPC2138的GPIO使用范例很好的代码-ucos under the ARM7, LPC2138 GPIO use the example of good code
ucos---GPIO-stm32f103
- 基于STM32f103vct的ucos操作系统下的GPIO程序-Based on ucos operating system under STM32f103vct GPIO
ucos---GPIO-stm32f107
- 基于STM32f107vct的ucos操作系统的GPIO程序。-Based STM32f107vct ucos operating system GPIO procedures.