搜索资源列表
18_uart
- 通过FPGA建立模块的串行的Verilog实现-Realized through the establishment of the module s serial verilog on FPGA
STM32_-USART
- 这个实验是STM32串口实验,中断接收数据。-This experiment is the experiment STM32 serial interrupt receive data.
communication-circuit
- 由于RS232的电平与Arduino Mega 2560的接口电平不能兼容,所以就需要进行电平的转换,即进行串口转换模块的设计,本文选择利用ATMEGA16U2-MU模块来做电平转换,将上位机的指令通过此模块发给下位机-Since the RS232 level is not compatible with the Arduino Mega 2560 interface level, so we need to level conversion, that is designed to seri
core-circuit
- ATmega2560通过USB接口与PC进行传输,供电电压为5V,内部晶振为16MHz。该芯片共有有54个I/O引脚,特别适用于需要大量I/O口电路,其中的16个可以提供脉宽调制(PWM)模拟输出,还有另外16个模拟输入引脚。在通信方面,有4个硬件串口,另外也可以支持SPI通信和I2C/TWI设备。设计核心电路中加入复位按键,通过USB串口进行通信。-ATmega2560 through the USB interface with the PC for transmission, power
licheng
- I2C串行总线的组成及工作原理 I2C总线的数据传送 80C51单片机I2C串行总线器件的接口 有完整的过程以及例子-Composition and working principle I2C serial bus data transfer 80C51 microcontroller I2C serial bus interface I2C bus devices have a complete process and examples
AD7731DATA
- 将AD采集的串行数据转换为并行数据,上传到ARM中-The serial data collected by AD is converted to parallel data, and uploaded to ARM
vlsi-design3
- 电路具有四路4_bit字宽的串行输入总线,四路4_bit字宽的输出总线信号的电路。 电路完成将串行输入信号A[3..0]、B[3..0]、C[3..0]、D[3..0](大小排列无序)以数值大小排序输出的功能,输出X3[3..0]、X2[3..0]、X1[3..0]、X0[3..0]中X3最大,X0最小。输入数据是无符号整数。 -Circuit with four 4_bit word wide serial input bus, four 4_bit word wide output
lv-maxsonar-ez
- With 2.5V - 5.5V power the LV-MaxSonar® - EZ1™ provides very short to long-range detection and ranging, in an incredibly small package. The LV-MaxSonar® -EZ1™ detects objects 0-inches to 254-inches (6.45-meters) and provi
5
- Check the clock frequency & that the baud rate required can be achieved. Error of <1 is never a problem, <2 will work but is undesirable, 5 will not work. Note that this assumes that the other end of the link has perfect timing, which will norm
rx_tx_interface_demo
- 精简的verilong串口通信源码,带通信自定义模块(Streamlined verilong serial communication source code, with communication custom module)
数字电位器-X9C104
- 这是一份数字电位器X9C104的文档,该芯片由intersil公司出品,3线串行接口,99个电阻单元,5V电源供电。(This is a digital potentiometer X9C104 document, the chip produced by INTERSIL company, 3-wire serial interface, 99 resistor units, 5V power supply.)
uart
- 瑞萨单片机RL78/G1D 串口驱动程序(RL78/G1D serial driver of Reza single chip microcomputer)
serial_adder
- 串行加法器的vhdl描述,用两个移位寄存器和一个全加器,一个d触发器实现(The VHDL descr iption of the serial adder, with two shift registers and a full adder, a D trigger)
ucos serial
- 串口 的 ucos 驱动编程,应该比较有用(ucos serial driver CommGetChar CommGetTxChar CommPutChar CommBufInit)