搜索资源列表
svc
- 电力系统无功补偿和谐波抑制matlab仿真程序 请大家多多指教-reactive power compensation and harmonic suppression Matlab simulation program please exhibitions
无功功率分离谐波成分和基波成分
- 无功功率分离谐波成分和基波成分，采用数学形态学滤波器作为低通滤波,Reactive power components of the separation of harmonic and fundamental components, the use of mathematical morphology filter as a low-pass filter
current_FFT
- 基于matlab对电力系统谐波分析源码，各次谐波幅值等-Matlab-based source of power system harmonic analysis
MATLAB
- 对噪声信号中的正弦信号，通过Pisarenko谐波分解方法、Music算法和Esprit算法进行频率估计，信号源是： 其中， ， ， ； 是高斯白噪声，方差为 。使用128个数据样本进行估计。 1、用三种算法进行频率估计，独立运行20次，记录各个方法的估计值，计算均值和方差； 2、增加噪声功率，观察和分析各种方法的性能。-Sinusoidal signal in the noise signal through the Pisarenko harmonic decomposition metho
ST
- 本程序是基于S变换的短时电能质量扰动检测方法实现的，用于分析电压暂降的幅值、相位跳变、持续时间和谐波含量进行分析-This procedure is based on the S transform short-term power quality disturbance detection method implemented for the analysis of voltage sag magnitude, phase transition, duration, and harmonic
triblebgebipole
- 三相PWM叠加三次谐波控制Simulink仿真，另加一滤波器观看PWM经过低通滤波后的波形，适合电力电子初学者-Superposition of three harmonic three-phase PWM control Simulink simulation, plus a watch PWM filter through after the low-pass wave filter for power electronics for beginners
iirh
- 利用IIR滤波器设计一个低通滤波器，能够分析到电力系统中的三次谐波，要求满足如下指标：截止频率150HZ，阻带衰减≥30db-IIR filter design using a low-pass filter, to analyze the power system in the third harmonic, the requirements to meet the following indicators: cut-off frequency 150HZ, stopband attenuat
firh
- 利用FIR滤波器设计一个低通滤波器，能够分析到电力系统中的三次谐波，要求满足如下指标：截止频率150HZ，阻带衰减≥30db-FIR filter design using a low-pass filter, to analyze the power system in the third harmonic, the requirements to meet the following indicators: cut-off frequency 150HZ, stopband attenuat
Reactive-power-optimization
- 利用线性规划法编写的MATLAB程序，用于电力系统无功优化，用于学习交流-Prepared by using linear programming MATLAB program for power system reactive power optimization for the Learning Exchange
ieeebasedswitchinglosesehormonicdostortin
- this is an ieee based simulink based projects for reducing the harmonic ditortion is the power systems
DetectionofFlickerCaused
- 详细描述了电力系统由于间谐波的引起的闪变，和原因-As described in detail between the harmonic power system caused by flicker, and the reasons
pisa
- 在计算机上产生一组实验数据，首先产生一段零均值白噪声数据u（n）,令功率为 ，让u(n)通过一个三阶FIR： 得到y(n). .y(n)上加三个实正弦信号f1’=0.1,f2’=0.25,f3’=0.26调整 和正弦信号幅度信噪比大致为10dB,50dB,50dB. (1) 令N=256,描绘xn波形； (2)得出真实功率谱密度 . (3) 利用此实验数据Pisarenko谐波分解法估计该实验数据的正弦频率及幅度。-On the computer to generate a
pisare
- 用Pisarenko谐波分解法估计一组实验数据的正弦频率及幅度。得出真实功率谱密度。-Pisarenko harmonic decomposition method with a set of experimental data estimate the sinusoidal frequency and amplitude. The true power spectral density obtained.
APF97
- 基于谐波电流快速检测方法的有源电力滤波器simulink仿真模型 -Current rapid detection methods based on harmonic active power filter simulink simulation model
powerharmonicanalysis
- 用快速傅里叶变换进行电力线谐波分析的一篇文章，大家可以-Fast Fourier Transform with the power line harmonic analysis article, we will look
D2
- simulink系统仿真：10kV 母线短路容量为10MVA，通过额定电压10/0.4kV，额定容量为100kVA，短路阻抗为5％的变压器与负荷相连， 阻感负荷RL 容量为50kVA，功率因数0.9。电力电子装置产生的5 次和7 次谐波电流均为5A；为了抑制7 次谐波在400V 母线处接入电容与变压器构成7 次滤波器。-simulink System Simulation: 10kV busbar short-circuit capacity of 10MVA, through the rate
Power-system-harmonic-measurement
- 电力系统谐波测量，用于分析电力系统谐波成分以比例-Power system harmonic measurement
Power-Quality-Generator
- 电力系统谐波发生器的MATLAB函数程序，可以产生各种谐波信号，包括谐波、电压骤升、电压中断、电压骤降、暂态脉冲信号等。-Power system harmonic generator MATLAB function procedures, can produce a variety of harmonic signals, including harmonics, voltage swells, voltage interruptions, voltage dips, transient pu
statcom_Apf
- STATCOM与有源滤波器的仿真，电流为滞环控制，含无功、谐波电流检测-STATCOM simulation with active filter, current hysteresis control, including reactive power, harmonic current detection
Constant Power Control of DFIG Wind Turbines
- 双馈式风机并网谐波控制研究，用于多台DFIG并网研究转子侧、电网侧、并网点谐波(Research on Harmonic Control of Doubly-fed Fan Connected to Grid. It is used to study harmonic waves on rotor side, grid side and grid point of multiple DFIG grid connection.)