搜索资源列表
jixiaozhi.rar
- 功能：用斐波那契法求f(x)在区间[a,b]上的近似极小值。当且仅当f(x)在[a,b]上为单峰时次方法适用,Function: The Fibonacci method f (x) in the interval [a, b] on the approximate minimum. If and only if f (x) in [a, b] for the single-peak method can be applied at times
Traffic_Light
- 交通灯除了有基本功能外，还有全部禁行、全部通行、南北方向通行、东西方向通行、高峰控制、警报提示、各方向各时段通行时间自定义、手动复位等。-In addition to the basic function of traffic lights, there are all the forbidden line, all traffic from north to south direction of traffic, east-west passage, the peak control, ala
Maxflow_MinCut
- 最大流最小割算法的VC++实现，用于得出网络原点到终点之间的最大流量限制。-The minimum cut VC++ flow of the algorithm is realized that network origin to finish between the peak flow restrictions.
program
- 脉搏读取,通过脉冲波段分析高峰低谷计算每分钟的心率情况。-Pulse by pulse wave analysis of reading, peak and low rate per minute.
QXX
- 用matlab实现基于db小波分析的心电图ECG峰值检测及其标记-Db using matlab wavelet analysis based ECG ECG peak detection and marking
music.1
- 对波达方向进行估计，通过MUSIC算法估计波达方向，利用MATLAB进行仿真，构造出谱峰图，估计出入射信号的个数和方向，有效的估计出独立信号源的DOA-Estimation of DOA estimated by MUSIC DOA algorithms using MATLAB simulation constructed peak figure, it is estimated the number of signal out of shot and direction, effective
ADC2_example2
- adc2_example_2 ADC2 Example2: ADC2 continuous conversion mode example @par Example descr iption This example provides a short descr iption of how to use ADC2 peripheral in continuous mode. Analog input voltage signal build microphon
A
- 信号压缩峰值计算，根据不同u值，计算信号的峰值，只需开始信号更改一下，可以直接使用-Peak signal compression
DZJLTF
- 地震动处理程序，可以处理地震动时程峰值和频率的程序-Seismic processing program can be used to ground motion peak and frequency processing
ggg
- the real power and reactive power waveform of STATCOM device with PI controller. The system settles down depending upon the gain values of PI controller. Due to the higher values of gain in PI controller, it causes peak overshoot in waveform at i
light
- 本程序在系统中利用单片机的定时器、IO接口、中断系统等资源，设计一个十字路*通信号灯的控制模拟系统。该系统尽可能模仿真实的交通灯系统，同时进行一些智能化设计，包括紧急状态处理，高峰状态处理等(This program designs a traffic signal control simulation system at crossroads by using the timer, IO interface, interruption system and other resources i