搜索资源列表
实验一（2） 交通灯模拟实验
- 汇编语言8255交通灯模拟实验-8255 assembly language simulation of traffic lights
PIC-LED
- led七彩灯程序，用的是pic单片机,对新手非常有参考的价值。-led colorful lights program, is the a pic microcontroller beginners reference value.
2timer
- 用两定时器，数字5432降至5398同时流水灯，到5398时灯同时闪烁，后数码显示HELO -Two timers, the number of 5432 fell to 5398 at the same time water lights, to 5398 when the lights flicker at the same time, after the digital display HELO
state_machine
- 状态机的描述，基于EasyFPGAv1.04 用状态机描述流水灯，状态机在1s的周期下流水灯，方向又sel控制-Descr iption of state machine, based on the state machine described by EasyFPGAv1.04 water lights, state machine at the cycle 1s under water lights, direction and control of sel
shansuodeng
- 基于lpc2103的led闪锁灯的实验 完整版 加开发资料及程序-Lpc2103' s led on the lock lights flash full version plus development of experimental information on procedures for
Light
- java3d中关于灯光的代码，希望对你有用-java3d code on the lights, I hope useful to you
3
- 用于令与PORTD口相连的8个发光二极管前4个点亮，后4个熄灭。在调试程序前，应使与PORTD口相连的8位拔码开关拔向相应的位置。-I used to make and PORTD LEDs connected to the eight first 4 lights out after 4. In the debugging process, should make PORTD I connected with the 8-bit code switch pulled to pull the c
a
- 按一个按钮两次相当于没按，每个按钮按或者不按的情况，一共有2^4=16种状态。枚举每个按钮是否按下，及时根据按键总数终止不可能的情况，注意按钮1==按钮2+按钮3的作用，因此在c 4==2时注意sum！=1的情况。虽然灯最多有100盏,但6盏以后的灯都是前6盏的重复，因此只需保存前六盏的状态。最后对所有合适的情况排序输出。-Equivalent to not press each button press or by pressing a button twice, a total of 2 ^
traffic-control
- 交通灯控制信号的代码，可以用来控制交通灯电路，控制灯的亮灭。-The traffic light control signal code can be used to control traffic lights circuits, control lamp light off.
CC2430
- 这是TI的cc2430程序，西安华凡科技有限公司实验板。里面有24个实验案例，包括LED灯控制等等。-This is TI s of cc2430 program, which there are 24 experimental cases, including the control of LED lights.
xunjixiaoche
- 利用循迹信号采集模块中的红外发射接收对管检测路面上的轨迹 将轨迹信息送到fpga，fpga将轨迹信息通过led灯显示出来，在通过fpga发轨迹信号给单片机，通过单片机来控制电机的转动。同时单片机将小车的状态反馈给fpga，fpga通过1602液晶显示小车的状态。-Infrared tracking signal acquisition module transmitting and receiving tube detection on the road trajectory to the
EDA
- EDA实验代码，有交通灯，流水灯，汽车尾灯，电梯，电子密码锁-The EDA experimental code, traffic lights, water lights, car tail lights, elevators, electronic password lock ~ ~
YKQ
- 五人表决器 三人以上同意则灯亮，否则不亮。-Three or more of five voting agree with lights, and otherwise does not shine.
jiaotongdeng
- 十字交通灯C实现代码，可以参考一下的很好的代码-Cross traffic lights implemented in C code
led_decoder
- 这个是用verilog语言写的一个点亮LED灯的程序，在DE2最小系统板里验证过-This is to use verilog language written by a light LED lights program, in DE2 minimum system board validated
paomadeng
- 跑马灯实验：利用计数器轮流点亮LED灯，实现各种动态效果。-Marquee experiment: the use of counter rotate the LED lights, to achieve a variety of dynamic effects.
Sample_4_6
- 使用java编写的，基于安卓系统的开发代码，主要功能为：两个按钮，实现开灯或者关灯。-Using java prepared, based on Android system development code, the main functions are: two buttons, turn on the lights or turn off the lights to achieve.
ss
- 白光8头光束灯的程序!唐胜版!白光8头光束灯的程序!唐胜版!8头白光光束测试程序（10次内确定关机有效，按确定关机为一次测试，10次测试后系统关闭，唐胜板（电机驱动是DRV8841））.hex-White 8 beam lights of the process! TANG Sheng edition! White 8 beam lights of the process! TANG Sheng edition! 8 white beam test procedures (10 times de
LEDaKey
- DSP的源码，和数据库，装有C5509的同学可以直接使用！整个的代码！有关按键与LED灯！-DSP source code, and databases with the students C5509 can be used directly! The whole code! For buttons with LED lights!
FPGA_-traffic-lights-control-
- FPGA_交通灯控制程序设计 是基于FPGA的智能交通灯控制系统-FPGA_ traffic lights control procedures designed FPGA-based intelligent traffic light control system