CDN加速镜像 | 设为首页 | 加入收藏夹
当前位置: 首页 资源下载 文档资料 软件工程 搜索资源 - attenuation

搜索资源列表

  1. WIFI

    0下载:
  2. WIFI信号应用很好的经验列表,在不同的介质信号衰减,覆盖的具体范围-WIFI signal applications experience a good list of signal attenuation in different media, covering the specific scope of
  3. 所属分类:Project Design

    • 发布日期:2017-03-31
    • 文件大小:6420
    • 提供者:xuelinfabg
  1. steam

    0下载:
  2. 本软件采用VB编程,用于分析工业上过热蒸汽在管道传输过程中的有用能衰减。-This software is programmed using VB for the analysis of industrial superheated steam in the pipeline transmission of useful energy attenuation.
  3. 所属分类:software engineering

    • 发布日期:2017-04-02
    • 文件大小:11645
    • 提供者:王星
  1. S259M

    0下载:
  2. This standard describes a serial digital interface for 525/60 and 625/50 digital television equipment operating with either 4:2:2 component signals or 4fsc composite digital signals. This standard has application in the television studio over
  3. 所属分类:software engineering

    • 发布日期:2017-03-29
    • 文件大小:105876
    • 提供者:李政
  1. PCB-desin

    0下载:
  2. 1、如何选择PCB板材? 选择PCB板材必须在满足设计需求和可量产性及成本中间取得平衡点。设计需求包含电气和机构这两部分。通常在设计非常高速的PCB板子(大于GHz的频率)时这材质问题会比较重要。例如,现在常用的FR-4材质,在几个GHz的频率时的介质损(dielectric loss)会对信号衰减有很大的影响,可能就不合用。就电气而言,要注意介电常数(dielectric constant)和介质损在所设计的频率是否合用。 -1, how to choose the PCB board
  3. 所属分类:Project Design

    • 发布日期:2017-04-17
    • 文件大小:125042
    • 提供者:tony
  1. Graphic-equalizer-circuit

    0下载:
  2. 用于控制音质的NF型调制控制电路,因仅能进行低音和高音的增强和衰减,所以不能进行细微的频率特性的补偿。述有,如果想使可听频带域的任意频率均可变,一般使用被称为图形均衡器的装置。这里使用DSP的例子在不断增加,如果要使用简单的电路则使用OP放大器较好。这种图形均衡器是将补偿的中心频率分割为5~7份,分别进行控制,由5个RLC电路组成,十分实用。分割的各个频率是以可听频率范围为对称轴均等分配而决定。-NF-modulation control circuit to control the sound
  3. 所属分类:Project Design

    • 发布日期:2017-03-31
    • 文件大小:224747
    • 提供者:邓杰文
  1. rev2

    0下载:
  2. 为达到干涉合成孔径声纳系统对信号源的特殊要求,提出了一种基于SOPC技术的FPGA实现方法,该信号源一方面提供给发射机模拟信号,还给回波信号采集系统提供时钟和同步信号以保证信号系统时间一致性,同时还给接收机的时变增益信号实现对回波信号衰减的补偿 另一方面还实时采集并传输声纳系统在水下的运动姿态、深度、压力等信息 经过湖试和海试,该信号源系统完成了模拟信号和数字信号各项指标的测试,满足设计要求。-To reach the special requirements interferometric s
  3. 所属分类:Project Design

    • 发布日期:2017-03-30
    • 文件大小:489720
    • 提供者:cooldog
  1. Untitled6

    0下载:
  2. h(n)的长度N没有给定,仅给定通带边缘截止频率wc和阻带临界频率ws,以及相应的衰减,用窗函数法设计线性相位FIR低通滤波器-h (n) of length N is not given, only given pass band edge cutoff frequency wc and stop band the critical frequency ws, and the corresponding attenuation window function design linear pha
  3. 所属分类:Project Design

    • 发布日期:2017-12-06
    • 文件大小:564
    • 提供者:王涛
  1. luboqi

    0下载:
  2. 设计一个8阶以内的带通滤波器,通带截止频率fc1=30070HZ,fc2=32170HZ,通带内允许最大衰减0.2dB。设计满足要求的Butterworth滤波器和chebyshev滤波器。以RC运放为基本单元以最易实现的原则完成电路设计及参数选择,并根据设计参数进行幅频特性和相频特性的仿真,给出仿真曲线。分析电路的无源灵敏度。-Design within an 8-order band-pass filter, the passband cutoff frequencies FC1 = 300
  3. 所属分类:software engineering

    • 发布日期:2017-11-07
    • 文件大小:58941
    • 提供者:
  1. ac

    0下载:
  2. 利用 MATLAB 实现窗函数法设计 FIR 滤波器,主要是选择合适的窗函 数进行截断运算 -Window function method using MATLAB to design FIR filter, main is to choose the appropriate letter for window blocking operations.First theoretically to approximate the unit i
  3. 所属分类:software engineering

    • 发布日期:2017-11-19
    • 文件大小:801
    • 提供者:zhaoyong
  1. net

    0下载:
  2. 本人自己总结的无源衰减网络的各种方案,对参加电子设计的各位可能有帮助-I own summary passive attenuation network of various programs, participating in electronic design may help you
  3. 所属分类:Project Design

    • 发布日期:2017-04-16
    • 文件大小:16034
    • 提供者:刘媛媛
  1. QQMsgLook

    0下载:
  2. 本水波实现源码可以随便使用,随便转载,但是希望尊重我的成果,我老婆马艳,我会对你很好的!实现思路:波能扩散,波能衰减,交换波能数据缓冲区,计算偏移量,判断坐标是否在窗口范围内,计算出偏移象素和原始象素的内存地址偏移量-The wave source can be easily achieved using random reproduced, but wanted to respect my results, my wife Ma Yan, I will tell you good! Reali
  3. 所属分类:software engineering

    • 发布日期:2017-04-01
    • 文件大小:494148
    • 提供者:张哥
  1. WaterWave

    0下载:
  2. 实现思路:波能扩散,波能衰减,交换波能数据缓冲区,计算偏移量,判断坐标是否在窗口范围内,计算出偏移象素和原始象素的内存地址偏移量-Realization of ideas: wave energy diffusion, wave energy attenuation, switching wave energy data buffer, offset calculation to determine whether the coordinates within the window, the c
  3. 所属分类:software engineering

    • 发布日期:2017-04-17
    • 文件大小:135283
    • 提供者:张哥
  1. NFS_ECG

    0下载:
  2. The performance of controlled complex dynamic systems inevitably suffers from various disturbances and uncertainties. Moreover, different faults (sensor and actuator faults for example) can occur. Sliding mode based observers have shown high perf
  3. 所属分类:Project Design

    • 发布日期:2017-04-03
    • 文件大小:202027
    • 提供者:ali
  1. rf-amplifier-design

    1下载:
  2. 本系统由前级宽带放大模块、增益控制模块、无源衰减模块、功率放大模块和直流稳压电源模块组成,具有0~60dB范围内手动连续调节、带宽为0.3M~100MHz的功能。在前级放大中,采用两片宽带低噪声放大芯片ADA4895级联对输入信号进行放大,然后由800MHz带宽的可变增益放大器AD8368进行放大倍数调节,最后通过低噪声电流反馈运放THS3001进行功率放大,从而达到1V有效值输出。在系统设计中,采用了合理的阻抗匹配,规范的高频线路布局和有效的散热设置,并且综合考虑了去耦、滤波,以及使用同轴电缆
  3. 所属分类:Project Design

    • 发布日期:2017-04-07
    • 文件大小:389750
    • 提供者:刘欣怡
  1. CIC-filter

    0下载:
  2. 采用多级级联方法降低了对硬件运算速度的要求,有利于实时处理;采用余弦滤波器改善了阻带衰减不足;内插二阶多项式滤波器补偿了 CIC 滤波器通带内的衰减;抗混叠低通滤波器减小了混叠影响-Using multi-stage cascade approach reduces hardware requirements for computing speed, real-time processing in favor cosine filter improves the stop-band atten
  3. 所属分类:Project Design

    • 发布日期:2017-04-08
    • 文件大小:742261
    • 提供者:xin
  1. Array-signal-processing

    0下载:
  2. 本论文的工作是对近场圆形阵列宽带信号进行处理,获得目标/焦点位置增益输出, 预先定义宽带信号阻带的旁瓣衰减大小以及感兴趣频域内的恒定波束宽带模式。本文使 用不同的方法解决这个设计问题,该问题分为两部分,第一部分解决频域内的模型设计, 第二部分给出时域内的结果。仿真结果表明解决方法的有效性。 -This thesis work is a circular array of broadband near-field signal is processed to obtain the
  3. 所属分类:Project Design

    • 发布日期:2017-05-09
    • 文件大小:1826489
    • 提供者:韩甜
  1. WLAN-loss-calculation

    0下载:
  2. WLAN设备的传播损耗计算模型,主要是指以下:Devasirvatham模型,也称为线性路径衰减模型,可用于各种建筑材料2.4G电磁穿透损耗的经验衰减因子模型信号的穿透损耗在这个阶段。-Both WLAN propagation loss calculation model is mainly refer to the following: Devasirvatham model, also known as a linear path attenuation model, the attenu
  3. 所属分类:Project Design

    • 发布日期:2017-04-26
    • 文件大小:13658
    • 提供者:gao xiangfeng
  1. Speech_segmet

    0下载:
  2. sThe choice of the window in short-time speech processing determines the nature of the measurement representation. A long window would result in very little changes of the measurement in time whereas the measurement with a short window would not be s
  3. 所属分类:software engineering

    • 发布日期:2017-04-25
    • 文件大小:354048
    • 提供者:thanh
  1. DECT_Paper

    0下载:
  2. We propose an empirical method to determine the proper decomposition function. In contrast to other decom- position algorithms our empirical dual energy calibration (EDEC) technique does neither require knowledge of the spectrum nor of the at
  3. 所属分类:software engineering

    • 发布日期:2017-05-13
    • 文件大小:2686081
    • 提供者:陈默
  1. FSK-demodulation

    1下载:
  2. 基于MSP430的FSK调制解调器,实现较容易, 抗噪声与抗衰减的性能较好, 在中 低速数据传输中得到了广泛的应用- The FSK modem based on MSP430 is easy to implement and has better performance of anti noise and anti attenuation.
  3. 所属分类:Project Design

    • 发布日期:2017-01-01
    • 文件大小:422912
    • 提供者:侯静
« 12 »
搜珍网 www.dssz.com