搜索资源列表
Example_281xEvPwm
- 该程序用来生成pwm波形，是一个工程项目，头文件和初始化都有。-The program used to generate pwm waveform, is a project header files and initialize all.
test1.vhd.tar
- Little program to test one actel pfga. Just make a simple pwm
test2.vhd.tar
- 2nd test off pwm in fpga card
test3.vhd.tar
- 3th test off controlable-pwm in fpga card
beeb
- 2440单片机pwm输出控制蜂鸣器响，要下载到RAM中-arm microcontroller pwm output control buzzer, to download to the RAM in the
18B20
- PIC单片机散热器节能温度控制器的工作原理 最容易实现节能控器控制功能的改造方案就是由PIC单片机来完成控制功能，温度信号经过采样、信号调理之后再输入到单片机，在单片机中由软件编程对模拟信号进行 A∕D转换，转换为数字信号，与设定的温度相比较，得到偏差量，运用模糊控制算法对温度偏差进行模糊化和解模糊运算，控制输出量。在不同的实际温度下，通过偏差的大小来调节输出固态继电器开通与关断时间，输出占空比可调的PWM信号，控制散热器的实际加热功率，这样就实现了节能控制的目的。温度控制器原理框图如1.1
AVRchengxufani
- 包含AVR单片机的AD,I2C，EEPROM,PWM,定时器，串口等功能进行分析并给出程序。-Include AVR MCU AD, I2C, EEPROM, PWM, timers, serial port, are discussed and give the program.
16PWM
- STC12c5a08s2调试通过的舵机脉宽16位精度控制。给有需要的人。用PCA快速模式和中断实现。-STC12c5a08s2 debugging 16-bit pulse through the steering precision control. To those in need. Use the fast mode and interrupt PCA.
ONDMASDE2
- mathi cal model of DSIM withe PWM-mathimathical model of DSIM withe PWM
89C5pwm
- C语言程序 单片机程序 C++ 基于89C52的PWM红外的解码资料-C
sonix26000programGuide
- SNC26000 Series is a series of 16 to 500 seconds one-channel single chip voice synthesizer IC. It built in a 4-bit tiny controller, I/O ports, PWMIO, internal RAM, ROM, and a PWM Direct Drive Circuit (PWM Voice). By programming through the tiny
Linuxexample
- 完成A/D测试代码，LED测试代码及PWM 测试代码-Complete A/D test code, LED PWM test code and test code
example8
- 基于NIOS_嵌入式软核处理器研究，实现宽度可变的PWM波，通过LED显示-Embedded soft core processor based on NIOS_ research, to achieve variable width of PWM wave, through the LED display
ver1.0
- Shutdown of the UC1842 can be accomplished by two methods either raise pin 3 above 1 V or pull pin 1 below a voltage two diode drops above ground. Either method causses the output of the PWM comparator to be high (refer to block diagram). The PWM
2812EV
- TMS320F2812 重点介绍EV模块中的定时器及其PWM电路-TMS320F2812 EV
Code
- Source code for Multifunction Power Assisted Wheelchair. Use 2 SPCE061A chips. Slave MicroChip used for Voice-control, Master MicroChip used for Assistive and Electric control Wheelchair. Input: 3 buttons, 3 switch, 1 ADC, 2 x 2phase A/B encod
PWM
- is used to vary the signal as indicated. be done by changing the width of the signal
Test_pwm_usart_pit
- this code s sample to configuration PWM PIT and .. AT91c7x256 in keil uvigen 4.0 compiler
pwm_ctrl
- Spatna 3E PWM module controller
jianpanPWM
- 本文涉及到键盘及霍尔传感器，单片机及电机等，主要是采集到的信息用PWM控制电机-This article related to the keyboard and the Hall sensor, microcontroller and motor, etc. The information collected is mainly to control the motor with PWM