搜索资源列表
uart from opencores
- 用VHDL实现串口 可以实现与pc机的通信 收发 中断都可以 效果比较好-VHDL implement serial port, it can communicate with pc, it can accept and send message, and it can be interrupted.
new-lins-uart-all
- 无私奉献，VHDL 源码，用于实现FPGA上的UART(串口控制器)，可以实现FPGA与单片机，PC机的串口通讯。
UART.rar
- 该程序是用VHDL编写的串口收发控制器程序，可以实现上位机和下位机之间的串口通信,The program is prepared to use VHDL serial transceiver controller procedures, can lower PC and the serial communication between
uart
- 串口通讯 PC发送FPGA接受后回传 verilog语言-uart verilog
UART
- 利用FPGA接受232芯片的串口数据，可以与PC进行串口通信-FPGA chip using the serial data received 232, serial communication with PC
uart
- 采用VHDL语言编写的串口驱动程序，已调试通过，能够实现同PC机的数据传输，可读性好，可移植性好-VHDL language using the serial driver has been debugged, to achieve the same PC, the data transmission, readable and portable
uart
- FPGA的串口模块，实现FPGA与PC机的串口通讯。-FPGA serial modules, FPGA implementation with the PC-Serial communication.
EP1C3_12_7_SPCTR
- 基于FPGA的信号采集及频谱分析，用VHDL编写，压缩包里是Quartus下的工程。AD采样用状态机实现，并存入LPM_RAM。设计了一个UART模块（也是状态机实现的），可将数据发到ＰＣ机上。-FPGA-based signal acquisition and spectral analysis, prepared with VHDL, Quartus compression bag is the next project. AD sampling state machine used to
UART
- minimum uart Image for transfer image to FPGA then read again by PC
my_uart_top
- 实现的功能如题，就是FPGA里实现从PC接收数据，然后把接收到的数据发回去。使用的是串口UART协议进行收发数据。上位机用的是老得掉牙的串口调试助手-To achieve the functions such as title, that is, to achieve FPGA receives data from the PC, and then receive data back fat. Using a UART serial port protocol to send and recei
cp_uart_6
- 用CPLD驱动UART转USB芯片CP2102的verilog代码，与PC通信 包括CP2102的配置 驱动等-Using CPLD to drive the USB-UART CP2102 interface. verilog code, then communicate with PC, including the configuration and drivers, etc.
s7enable_send0x55_UART_9600
- 最简单的UART发送程序，vhdl编写，系统时钟40M，波特率9600，外Load有效（一个高脉冲）即向PC发送一个字节0X-UART to send the simplest procedures, vhdl prepared, the system clock 40M, baud rate 9600, outside the Load effective (a high-pulse) to the PC sends a byte 0X55
uart
- uart-universal aynchronious reciever and transmitter used to connect the pc and fpga to pass the data
S7_PS2_RS232
- 利用cpld作为cpu控制器将ps2中取得按键值通过串口传送给pc机-cpld verilog ps2 UART
uart
- 程序说明: 本次实验控制开发板上面的串口，与PC机进行通信，并在串口精灵里面显示字符。 目录说明: 工程在\project文件夹里面 源文件和管脚分配在\rtl文件夹里面 下载文件在\download文件夹里面,.mcs为PROM模式下载文件,.bit为JTAG调试下载文件。-Procedure Note: The experimental control development board above the serial port to communicate wit
FT2232H_USB_Core
- 在FPGA外扩用FT2232 实现UART TO USB 2.0 的通信。-The FT2232H is a USB2.0 Hi-Speed USB Device to FIFO IC. This core allows the use of this chip with an FGPA design in high speed FT245 style synchronous FIFO mode. Data rates up to 25 mbytes/s can be achieve
UART_communication
- it s a document where described rs232 communinication between pc and fpga . it describe the vhdl structure of uart driver in fpga that allow communication between this devices
A-Simplified-VHDL-UART
- In embedded systems, the processor that we choose for our design may not come with built-in peripherals. Therefore, designers will have to implement these devices in hardware keeping in mind that they will need to interface to the processor. In this
uart1
- vhdl uart module. this file is used to transfer programs frm fpga xilinx spartam 3e kit to desktop pc through rs232 serial port.
uart
- RS232通信程序，用于实现PC端与FPGA之间实现串口通信(RS232 communication program for realizing serial port communication between PC and FPGA)