资源列表
keys_control
- 按键按下开始计数,当计数超过200次,表示按下有效,确认按键打开后,开始程序处理。-count when a key is pressed. when reached 200 times and the key is released then the code for the key starts to run.
yyx_prbs_m
- 此程序是用MATLAB产生的PRBS信号。用在测试系统,控制系统中-This program is a PRBS signal generated using MATLAB. Used in the test system, a control system
moxing
- 在MATLAB中建立的电机的模型和仿真,可以用来分析控制系统。-Modeling and simulation of the motor built in MATLAB can be used to analyze the control system.
matlab
- 用遗传算法实现函数最优化问题,程序源代码,包括适应度函数,选择,交叉,变异等函数文件。-Using genetic algorithm to realize the function optimization problem, the program source code, including the fitness function, selection, crossover, mutation function such as file
Camera
- C++ 调用 摄相机 实现拍照-C++ open CAMERA
QtCameraDetect
- qt 调用相机,实现图像拍照并进行处理 图像处理-qt call camera, photographed and processed for image
DM9000
- 此程序是以网卡DM9000作为例子修改的驱动程序,驱动程序的修改在里面有标识-This program is modify the driver, the driver DM9000 network card as an example of modification in which a logo
2014-6-15-20
- 智能家居 串口通信 BEE 采集外部信号 C# -Smart Home serial communication BEE acquisition of external signals C#
nand-flash
- 此程序是NAND flash驱动程序的移植,移植部分在文中注释-This program is a NAND flash driver transplantation, part of the comment in the text
LCD
- 此程序是在linux系统下编写的LCD驱动程序,可以直接写应用-This program is under linux system prepared LCD driver, you can write directly to apply
USB
- 此程序是编写的USB驱动程序,是以USB设备,编写的驱动-This program is written in USB drivers, based on the USB device, write drivers
wang-luo-
- 此程序是写的网络设备驱动程序的步骤,编写发包和收包-This program is a step to write the network device driver, the preparation of contract and receiving packets
