资源列表
hydraulic
- 三相电弧炉的液压系统模型。模型里已经有参数了，由于每个液压系统参数不一样，需要自习查找相关资料自行修改参数。-Hydraulic system model of three-phase arc furnace
three_phase_circuit
- 三相电路的电气模块仿真模型。里面已经包含了电弧模型。根据变压器不同请自行修改相关参数。不含有电抗器也不含有挡位值-Simulation model of three phase circuit.Does not contain the reactor does not contain the value of the block
controlled_object
- 三相电弧炉的被控对象模型。包括电气部分，液压部分以及电弧模型部分。根据需要自行修改参数。看不懂可以找我的其他上传资料。-Controlled object model of three phase arc furnace. Including electrical part, hydraulic part and arc model part. Modify parameters as needed. Do not understand can find my other upload info
8shumaguan
- 基于ARM2103嵌入式开发8位数码管显示程序，程序完整，适合新手学习-Digital tube display
usb-sport-control
- 纯软运动控制源代码，包括算法(控制板与PC通过USB连接)-Pure soft motion control source code, including algorithms (control board and PC connected via USB)
shizixiu
- 用Matlab研究十字绣中线长最短的源代码-Using Matlab to study the shortest source of cross stitch midline source code
S10420
- 基于STM32的CCD 图像传感器S10420驱动源码 实际测试有效，能过产生驱动-STM32-based CCD image sensor S10420 drive source code is actually tested, can produce a drive
usart1usart2
- 串口1串口2互相转发对方收到的数据，串口2转发串口1收到的数据，串口1转发串口2收到的数据，stm32-Serial port 1 serial port 2 forward each other to receive the data, the serial port 2 serial port 1 received data, serial 1 forwarding serial port 2 received data, stm32
gpio_mio
- ZYNQ 的gpio 可以通过MIO 引出到PS 端的引脚，本例子 的gpio 通过MIO 引出，控制LED 灯D29。-ZYNQ GPIO can be drawn to the PS through the MIO pin, this example GPIO led by MIO, control LED lamp D29.
SHT-20
- 基于STC系列单片机的湿温度传感器SHT-20驱动代码，实际测试有效-Based on STC series of single-chip wet temperature sensor SHT-20 drive code, the actual test is valid
concrete-bone
- 模拟三维混凝土介质中的碎石粗骨料及水泥砂浆-3D concrete bone
bpsk
- 基于matlab的通信编程，限制幅值的Bpsk系列的程序，实际测试有效-Based on matlab communication programming, limit the amplitude of the Bpsk series of programs, the actual test is valid