资源列表
sl2101
- ZARLINK SL2101 C51驱动程序，内含i2c通信源码-ZARLINK SL2101 C51 driver i2c communication contains source
uv1316
- ＮＸＰ ＵＶ１２３６高频头 C51驱动程序，内含i2c通信源码-NXP UV1236 tuner C51 driver i2c communication contains source
linuxchuancan
- 内核参数传递 此参数指明包含引导扇区的设备名（如：/dev/had），若此项忽略，则从当前的根分区中读取引导扇区。-Kernel parameter to specify this parameter contains the boot sector of the device name (such as:/dev/had), if this neglect, from the current root partition boot sector to read.
chengxu2
- 动态LED显示程序.说明动态扫描，使用的是LED动态显示方法。在动态LED显示程序中，邪恶扫描字位口，是西萨内不同字位数据的动态显示效果-Dynamic LED display program. Note the dynamic scanning, using a dynamic LED display. LED display in a dynamic process, the evil bit I scan the word is different Western-bit data wor
bulkloop
- 用Cypress单片机FX2实现数据采集的固件程序，使用了端点0作为输出，端点2做输入，进行数据的处理。-With Cypress Singlechip FX2 firmware to achieve data acquisition procedures, the use of endpoint 0 as output, so the endpoint 2 input, for data processing.
serial-nrf24e1
- nrf24E1单通道带超时判断无线收发：调试完nrf9e5后就继续调试的，不支持跳频。-nRF24E1 with overtime to determine single-channel wireless transceiver: End debug after nRF9E5 continue debugging, do not support frequency-hopping.
yejing
- 液晶显示程序，实现的功能主要是通过查询显示输出按下的键号。-Liquid crystal display process to achieve the functions of the main display output through the query by pressing the button number.
24e1-serial
- 24e1根据接收字节判断的无线发送程序，例子中设定的为4个字节，可修改。-24e1 byte of the receiving wireless send procedures to determine, for example, set to 4 bytes can be modified.
UCOSIIGPRS
- 周立功SMART ARM2200上GPRS源码,快下吧,好东西-SMART ARM2200 Ligong weeks on GPRS-source, fast, are you, good things
example
- 周立功开发板源代码,里面包含了各种关于周立功dp51开发板的源代码-Week Ligong development board source code, which contains a variety of on-week Ligong dp51 development board s source code
ASM72
- 瑞萨单片机用的一种,少见,少用,难找,但是它单片机很便宜,-Renesas single-chip microcomputer with a rare, less, difficult to find, but it is very cheap single-chip,
yu_can_bus
- ARM接收到CAN总线的数据会在终端现实，同事实用CAN控制器发送的数据在终端返显。-ARM received CAN data bus terminal will be a reality, colleagues practical CAN controller to send data back to the terminal marked.