资源列表
SemanticAndaptationofNeuralNetwork
- Semantic analysis of multimedia content is an on going research area that has gained a lot of attention over the last few years. Additionally, machine learning techniques are widely used for multimedia analysis with great success. This work pre
MCU
- 这是关于51单片机的简单程序——电子钟板键功能，可以直接拷贝到KEIL51中去运行~希望对新手有帮助-This is simple on the 51 SCM process- electronic bell plate key functions, can be directly copied to KEIL51 going to run ~ hope to help novice
car
- 这是我上次参加电子设计大赛的小车程序，包括向前向后 左右转，走矩形，圆，-This is my last time to participate in electronic design contest procedures of the car, including the forward backward turn around and take the rectangular, round,
STI51
- STI51单片机开发板简介,对此类开发很有帮助-About STI51 Singlechip development board, development of such useful
ADCONTRL0804
- 对ad0804的控制工程，编译通过，希望对大家有用-Ad0804 control on the project, the compiler is passed, hope for all of us useful
TLC548_TLC549
- TLC548的介绍应用，8位串行模数转换器TLC548_TLC549的应用-TLC548 presentation applications, 8-bit serial ADC TLC548_TLC549 Application
timer
- 定时设计一个单片机控制的简易定时报警器。要求根据设定的初始值（59-1秒）进行倒计时，当计时到0时数码管闪烁“00”（以1Hz闪烁），按键功能如下： （1）设定键：在倒计时模式时，按下此键后停止倒计时，进入设置状态；如果已经处于设置状态则此键无效。 （2）递增键：在设置状态时，每按一次递增键，初始值的数字增1。 （3）递减键：在设置状态时，每按一次递减键，初始值的数字减1。 （4）确认键：在设置状态时，按下此键后，单片机按照新的初始值进行倒计时和显示。如果已经处于计时状态则此键无
danpianji
- 单片机介绍入门，有兴趣的话可以-Introduced single-chip entry, who are interested can
rtc
- 使用WINBOW78E365的RT1308的IIC读取C代码-RT1308 use of WINBOW78E365 read C code of the IIC
SPI-EEPROM
- SPI接口EEPROM的控制，实现了对于AT93C系列EEPROM的读写控制。-SPI interface EEPROM control, achieved AT93C Series EEPROM for reading and writing control.
RS-485mutil-communication
- 基于RS-485的多机通信，能在单片机上轻松实现，加快开发-Based on RS-485 Multi-machine communication, can easily achieve single-chip, to speed up the development
alone-keyboard-control
- 包含三个设计：独立式查询键盘的设计，独立式中断 键盘的设计-Contains three design: an independent inquiry keyboard design, the stand-alone design of the keyboard interrupt