资源列表
pilvfasheng
- 有LCD菜单的 频率发生器制作资料-There are LCD menu frequency generator production of information
51dingshi
- 一个基于51单片机的定时报警设计电路及程序-51 Single-chip based on the timing and procedures for alarm circuit design
LED_Controller_Design
- 能够显示4个汉字的源程序，通过硬件调试。本程序带了Proteus仿真，可以方便地进行调试，改变汉字点阵码可以显示自己想要的汉字。-Able to show four characters of the source, through hardware debug. This procedure with the Proteus simulation, debugging can easily change the characters dot matrix code can show the c
f2caef92-e9c9-4e1a-befe-b4a3b93bf1aa
- bin和hex格式文件相互转换，bin和hex格式文件相互转换-bin and hex format conversion, bin and hex format conversion
AVR_T0_SqareWave
- 利用Atmega16单片机的定时器T0设计的方波发生器-ATmega16 MCU use T0 timer square wave generator design
AVR_T2_SqareWave
- 利用ATmega16单片机的T2定时器产生方波的控制程序-T2 to use ATmega16 MCU timer generated square-wave control procedures
jishushizhong
- 用EDA开发板实现的24小时计数时钟，编程环境为MUXPLUS2.-EDA development board used to achieve the 24-hour count of the clock, programming environment for MUXPLUS2.
clock
- set（key6） left（key5） right（key4） up（key3） down（key2） OK(key1) 功能一：时钟 时钟计时； 按下set（一次）键即可调时间，此时时钟计时停止，按left，right左右移动点，移动到需调的的数码管， 按up，down进行数字的调节，按OK键保存退出。 功能二：整点报时和闹钟 当时钟走到整时时，报时滴滴响四次； 按set（二次）键进入调节闹钟，此时时钟继续走动，按left，rig
LT-1B_MSP430JTAG
- 天祥电子-10天学会MSP430单片仿真器电路图\LT-1B_MSP430JTAG.rar-Institute of Electronics-10 days Tienhsiang MSP430 monolithic circuit emulator LT-1B_MSP430JTAG.rar
1616
- 基于8051单片机的16*16点阵proteus仿真，程序为汇编设计,程序为本人设计（具体可以联系lzs827@qq.com） 16*16点阵显示汉字带滚动功能，绝对不是从网上下载-Based on 8051 16* 16 lattice Proteus simulation, procedures for the compilation of design, process design for the I (specifically can contact lzs827@qq.com)
RS232
- 天祥电子-10天学会MSP430单片机LT-1B串口232例程-Institute of Electronics-10 days Tienhsiang Singlechip MSP430 serial LT-1B routines 232
LED
- 天祥电子-10天学会MSP430单片机LT-1BLED例程-Institute of Electronics-10 days Tienhsiang MSP430 Singlechip LT-1BLED routines