资源列表
FAT16-DemoCode
- FAT16 读写的演示代码, 附文件说明-Read and write FAT16 demo code, attached document describes the
ARM_SourceCode0.7
- 适用於ARM的SD/MMC读写FAT的源码-Applicable to ARM s SD/MMC to read and write FAT source
avr128-lcd-display
- 基于mege128单片机的lcd菜单显示-Lcd-based SCM mege128 menu display
avr128-zhidaoshu
- ATMEGA 128 单片机训练指导书 -ATMEGA 128 Singlechip training guide book
SD_card_Code
- C语言写的 SD card 的控制程序, 程序中有详细的说明-C language to write the SD card of the control procedures, the procedures described in detail
c51
- 单片机系统设计与C51编程实践，很值得下载的-C51 single-chip system design and programming practice, it is worth downloading
square
- 按下16个矩阵键盘依次在数码管上显示1-16的平方。如按下第一个显示1，第二个显示4... 在keil下编程，用proteus仿真 -Press the keyboard matrix followed by 16 in the digital tube display the square of 1-16. Touching the first show that 1, the second show the next 4 ... in keil programming, sim
frequency_of_MCS-51
- 用51单片机做的数字频率计，精度非常高，计数误差不超过1Hz。量程0--65535.-Singlechip do with 51 digital frequency meter, the accuracy is very high, counting error of less than 1Hz. Range 0- 65535.
169
- msp430f169经典例程，这些程序我都试过，非常有用-msp430f169 classic routines, these procedures I have tried, very useful
eee
- 设计一个彩灯控制器，具体要求如下： 1. P1端口外接8个LED灯，LED0－LED7。 2. 彩灯闪耀方式自定，闪动频率为1s。 3. 具有彩灯启、停控制功能，控制方式自定。 4. 利用单片机内部定时器，要求采用中断方式。 已知系统主频为8MHz。-To design a lantern controller, specific requirements are as follows: 1. P1 port external eight LED lights, L
DDS
- 一个基于AD9954的430单片机编程，液晶使用的是FYD12864-AD9954 430-based single-chip programming, LCD using FYD12864
bianma
- 本程序使用于，2051单片机开发的遥控编码器-This procedure used, 2051 single-chip developed by remote control encoder