资源列表
STC12C2052AD
- 电压电流表程序，供大家学学，有机会多多交流-Voltage ammeter procedures, for all to learn, there are numerous opportunities for the exchange of
STM32_USART_Pol
- stm32 编程学习篇之 串口通信，有详细的注释-stm32 programming of serial communication
sd_card
- PIC18F4520单片机，读SD卡程序，通过串口调试助手可以查看-PIC18F4520 microcontroller, reading SD card program, through the serial port debugging assistant can view the
datalink-selective 数据链路层—选择性重传协议
- 数据链路层的选择性重传协议的编写。在仿真环境下编程实现有噪音信道环境下 两站点之间无差错双工通信。信道模型为8000bps 全双工卫星信道，信道传播时延270毫秒，信道误码率 为10-5，信道提供字节流传输服务，网络层分组长度固定为256字节-The data link layer selective retransmission protocol preparation. In the simulation environment, programming environment,
st308
- ST308的数字功放的原理图和I2C控制软件-The ST308' s digital power amplifier schematic and I2C control software
ad9854的的SPI在MSP430的应用
- ad9854的的SPI在MSP430的应用，能够输出稳定的波形
ISD4004
- ISD4004语音芯片程序 自己给他增加了播放地址的读取和显示功能-ISD4004 voice chip program to him increase his broadcast address, read and display
16bitpwm
- // 程序实现PCA模块0和1的16位PWM输出Ｊ涑鼋臗EX0配置在P0.0脚输出方波占空比为2/3
Unicode_To_GB2313
- Unicode码 转 国标2313码 原代码；标准C编写；适合任何编译环境-Unicode code transfer GB 2313 yards of the original code standard C preparation suitable for any build environment
sim300 GPRS
- SIM300收发GPRS数据程序，包含GPRS连接的建立，数据发送及检测发送状态。-SIM300 procedures to send and receive GPRS data, including the establishment of GPRS connection, data sent and test sending state.
ARMcore
- 基于FPGA的ARM IP核！该软核VHDL源码全部开放-FPGA-based ARM IP core! The soft core VHDL source code are all open
keyscaner
- 自己设计的矩阵键盘扫描程序，实现5X4键盘扫描，带有去抖和中断功能。-Their own design matrix keyboard scanner, to achieve 5X4 keypad scanning, to shaking and interrupt functions with.