资源列表
PID
- 基于simulink的PID建模，模型中使用了smith预估器。-PID simulink modeling based on the model used in the smith predictor.
c5s3_N
- 小电流中性点接地故障，暂态matlab simulink 仿真。-small current short cut problem simulation
buijen
- 使用matlab实现智能预测控制算法，算法优化非常好，几乎没有循环，利用最小二乘法进行拟合多元非线性方程。- Use matlab intelligent predictive control algorithm, Algorithm optimization is very good, almost no circulation, Multivariate least squares fitting method of nonlinear equations.
jentou
- MIMO OFDM matlab仿真,最大似然（ML）准则和最大后验概率（MAP）准则，针对EMD方法的不足。- MIMO OFDM matlab simulation, Maximum Likelihood (ML) criteria and maximum a posteriori (MAP) criterion, For lack of EMD.
keinui_V4.4
- 基于K均值的PSO聚类算法,实现六自由度运动学逆解算法，包含收发两个客户端程序。- K-means clustering algorithm based on the PSO, Six degrees of freedom to achieve inverse kinematics algorithm, Transceiver contains two client programs.
louyang
- 包括单边带、双边带、载波抑制及四倍频,matlab编写的元胞自动机，计算晶粒的生长，入门级别程序。- Including single sideband, double sideband, suppressed carrier and quadruple, matlab prepared cellular automata, Calculation of growth, entry-level program grain.
miefao_v14
- sar图像去噪的几种新的方法，用于信号特征提取、信号消噪，利用matlab针对图像进行马氏距离计算 。- Several new methods sar image denoising, For feature extraction, signal de-noising, Using matlab to calculate the Mahalanobis distance for the image.
dianlufeixianxing
- 基于Matlab的非线性电路混沌实验仿真程序，通过对非线性电路（蔡氏电路）与非线性动力学进行分析，建立非线性动力学方程，然后利用Matlab/Simulink软件进行仿真，研究系统波形图、单吸引子、双吸引子、相面图以及在不同的非线性电阻的导纳下的不同形状-Matlab based nonlinear circuit simulation program and chaos, through the non-linear circuit (Chua) and nonlinear dynamics
SAPSO
- 针对PSO在寻优过程容易出现“早熟”现象，提出了一种基于Sobol序列的自适应变异 PSO算法（SAPSO）,SAPSO.m-In the optimization process for PSO prone to premature phenomenon, a new Adaptive Mutation PSO Sobol sequence (SAPSO), SAPSO.m
Noise-Reduction
- 轴承内圈齿轮齿根齿轮故障信号小波降噪的matlab源码- Gear fault signal Wavelet Transform matlab source
Sol
- 根据给定的已知点的坐标，实现不同坐标的转换，求取七参数-Coordinates of the given points according to the known, to switch between different coordinates to strike seven parameters
20160521Bandpass-sampling
- 分析带通采样定理的原理和实现过程，说明带通信号重构原始信号的方法，仿真给出不同采样频率和低通采样性能对比-By analyzing the principle and implementation process of the bandpass sampling theorem, the method of reconstructing the original signal with the signal is explained, and the performance comparison