资源列表
RM001V1.0
- RM6T6跑步电机程序，实现电调与电机的通信。(RM6T6 running motor program, to achieve electrical adjustment and motor communications.)
Timers
- TIMER PROGRAME USING SCHARC PROCESSOR
dr6—ise-F
- 用FPGA开发板的按键作为电子表的时间初值设置控制信号，数码管当前时间值输出。用按键选择分别输出：分、秒、1/10秒。(With FPGA development board button, as the time value of the electronic table, set the control signal, digital tube current time value output. Select output by buttons: minutes, seconds, and
低频部分-时域积分-平均-C语言-测试
- 列出的轨迹c语言，低频部分-时域积分-平均-C语言-测试(List the trajectories of C language, low frequency part time domain integral - mean -C language - Test)
270-90-900 36s 稳定
- 51单片机小车程序，自动寻迹，通过计时器，红外线传感器(51 singlechip car procedures, automatic tracing, through timers, infrared sensors)
IR_SendData
- stm8发送红外功能代码，可参考学习，使用定时器TIM2的通道CH1输出38KHz的波形(stm8 Send ir function code)
按键密码
- 可以实现按键密码解锁功能，用LED显示解锁成功或者失败。(You can unlock the key password and use the LED to display the success or failure.)
STM8S_StdPeriph_Lib_V2.1.0
- 比较主流的V2.1的固件库和一些官方的示例程序(Compare the mainstream V2.1 firmware library and some official sample programs)
光立方
- 用8*8*8光立方显示任意形状字体，C51单片机keil软件编程。(Use light cube display font, C51 microcontroller programming.)
TIM1
- 程序初始化了定时器1，并通过DMA传输修改PWM占空比，方便用来实现快速SPWM(Program initialization timer 1, and through the DMA transmission, modify the PWM duty cycle, easy to use to achieve fast SPWM)
SysUART
- 程序初始化STM32F030 uart1和DMA，并通过DMA接收和发送不定长串口数据(The program initializes STM32F030, uart1 and DMA, and receives and sends the indefinite long serial data through the DMA)
SysADC
- 程序初始化STM32F030的ADC1，并通过DMA传输转换的ADC结果(The program initializes the STM32F030 of the ADC1 and passes the ADC results converted by DMA)