资源列表
LPC11C14
- 基于Cortex-M0的LPC11C14各个模块的裸机程序，每个模块都有详细例程解读。-demo of M0
Periodic32bitT0Ints_4F120
- 在特定时间内使用Timer0的32位周期模式中断，测量期间观察连接到PF3-1上的示波器或LED 在使用的色轮的时候，PF2端口上的蓝色LED有四个连续中断，然后关闭四个连续的中断。-Use Timer0 in 32-bit periodic mode to request interrupts at a particular period. oscilloscope or LED connected to PF3-1 for period measurement When
PeriodMeasure_4F120
- 在要求中断的上升边缘PB6（T0CCP0时间模式使用Timer0A，并且在相邻脉冲之间测量周期。 注意：外部信号连接到7:6（T0CCP0）（上升沿触发）-Use Timer0A in edge time mode to request interrupts on the rising edge of PB6 (T0CCP0), and measure period between pulses. external signal connected to PB6 (T0CCP0
UART2_4F120
- 从运行超级终端的计算机上运行测试UART0并实现双向数据转移。这一次，我们使用了中断和FIFO。-Tests the UART0 to implement bidirectional data transfer to and from a computer running HyperTerminal. This time, interrupts and FIFOs are used. U0Rx (VCP receive) connected to PA0 U0Tx
Timer0APWM_4F120
- 在PWM模式下使用Timer0A产生给定周期和占空比的方波。 Timer0A使用PF0或PB6。 使用PB6，是因为连接到开发板上的SW2。-Use Timer0A in PWM mode to generate a square wave of a given period and duty cycle. Timer0A can use PF0 or PB6. PB6 is used because PF0 is connected to SW2 on the Launchpad.
SysTick_4F120
- 通过激活PLL测试系统定时器功能，初始化系统定时器，以恒定的速率闪烁LED。PF2是用于调试的输出-Test the SysTick functions by activating the PLL, initializing the SysTick timer, and flashing an LED at a constant rate. PF2 is an output for debugging
InputCapture_4F120
- 在边缘时间模式下使用Timer0A要求中断的上升边缘PB0（CCP0），并且计数脉冲。 外部信号连接到PB6（T0CCP0）（上升沿触发）-Use Timer0A in edge time mode to request interrupts on the rising edge of PB0 (CCP0), and count the pulses. external signal connected to PB6 (T0CCP0) (trigger on rising e
12864-serial
- 能够逐个显示汉字的12864串行接口，实用-12,864 Chinese characters can be displayed individually serial interface, practical
ADXL345
- 基于51单片机，用ADXL345开发的一个单次敲击检测程序，可供后续开发。-Based on 51 single-chip, with the ADXL345 development of a single tap detection program for subsequent development.
jiasudu
- 基于MPU6050加速度传感器的检测代码，可供后续开发借鉴。-Based MPU6050 acceleration sensor detection code for subsequent development of reference.
USB-COMM-DRIVE
- USB 转串口线驱动，用于单片机的系统开发。-USB to serial line driver for single-chip system development.
SRC
- AVR并行编程器主程序 -Parallel Programmer AVR mainParallel Programmer AVR main