资源列表
S3C44B0X-i2c
- S3C44B0X i2c S3C44B0X i2c-S3C44B0X i2c S3C44B0X i2c S3C44B0X i2c
GPIO_INT1
- * 文件名称：GPIO_INT1.C * 功 能：使用外部中断2进行蜂鸣器的控制。产生的中断（低电平有效）控制蜂鸣器状态。 * 使用非向量中断方式。 * 说 明：使用实验连接导线连接GPIO接口的[IO.1]到[BUZZER]插孔； * 实验时将连接导线的一端连接[INT/PWM]插孔，另一端接触[GND]插孔获得低电平。-ARM7 GPIO
interrupt
- 外部输入中断源INT0和INT1，由中断控制寄存器TCON的IT1（TCON.2）和IT0（TCON.1）分别控制外部输入中断1和中断0的中断触发方式。若为0，则外部输入中断控制为电平触发方式；若为1，则控制为边沿触发方式。 -INT0 External interrupt source input and INT1, the interrupt control registers TCON the IT1 (TCON.2) and IT0 (TCON.1), respectively ex
SD2068Amarket1.4
- SD2068 是一种具有标准IIC 接口的实时时钟芯片,CPU 可使用该接口通过5 位地址寻址来读写片内32 字节寄存器的数据(包括时间寄存器、报警寄存器、控制寄存器、通用SRAM 寄存器)。-SD2068 is a standard IIC interface with real-time clock chip, CPU can use the interface addressing the 5-bit address to read and write on-chip 32-byte re
sd2068_430
- 这是一个实时时钟芯片的430单片机的C语言程序设例-This is a real-time clock chip microcontroller 430 cases of C-language program designed
2440_led
- 本源码是基于OK2440开发板上红绿小灯的测试程序。-The source is based on the small red and green lights OK2440 development board test program.
misc
- Arm stm32 driver for cortex m3
2440-serial
- 本程序是基于OK2440开发板的串口1的收发测试程序-This procedure is based on OK2440 development board test program to send and receive serial 1
2440-RF
- 本程序是基于OK2440开发板的红外模块的测试程序-This procedure is based on OK2440 development board test program to send and receive serial 1
EmbeddedSystemsAndLabsForARM-V1.1
- a reference book for students who want to study ARM embed.
AMBA_SPEC.pdf
- The comprehensive standard document of the ARM AMBA bus protocol. It contains a rich set of the timing diagrams relating to different protocols and well defined parameters for them.
MSP_EXP430F5438(A)-Example-Software
- Msp 5438 Example Software-Msp 5438 Example Software