资源列表
xc3sa
- xilinx spartan xc3a bsdl
nuc900-lwip-source
- winbond nuc900 lwip source code
SPI
- 该程序实现了飞利浦嵌入式处理器LPC23XX的SPI功能，对工业控制是很好的参考。-The program implements the SPI Philips embedded processor LPC23XX function, industrial control is a good reference.
SSP
- 该程序实现了飞利浦嵌入式处理器LPC23XX的SSP功能，对工业控制是很好的参考。-The program implements Philips embedded processor LPC23XX the SSP function, industrial control is a good reference.
EasyStarterARMprogram
- 轻松入门开发ARM程序，对于初学者非常有用，包含了丰富的源例程-Easy Starter ARM program, very useful for beginners, including a rich source of routine
ARM-Executable-Image-for-LPC24xx
- nxp公司新出的芯片lpc2478工程模板，包括硬件初始配置-nxp lpc2478' s new project templates out of the chip, including the initial configuration of hardware
rf_can_working
- Here is the working code of CAN controller with lpc2129 - ARM and rf code is also added to communucate wiyh 8 bit controller
chap1
- matlab下基于Lugre摩擦模型的PID控制，-the PID control based on Lugre model
LPC2468EtherNet
- 这是我做以太网用到的LPC2468程序，部分已经做了改动，程序也调试出来了，有很好的借鉴意义。-This is what I used to do Ethernet LPC2468 process, some changes have been made, the program has debug out, there is a good reference.
jianpan
- 数控电源,俄罗斯方块，自行车程序，红外遥控爬虫机器人，混合电压设计-NC power, the Russian box, bike program, infrared remote control robot reptiles, mixed-voltage design
PxGLCD
- Interfacing LPC2124 with GLCD : image display, data display and pixel ON/OFF. Adapted the code to fine tune and make robust. The proteus DSN file also contain temp sensor and SPI EEPROM. But the source code is only limited for GLCD displa
PxGLCD
- LPC2124 interfacing with Temp sensor TC1047A The temp is display on GLCD LM3228 Temp formatting is done for -40 C to +125 C only. This source code contains interface for Temp sensor and GLCD only. I m in the process of adding source code