资源列表
PICREF-2-source-code
- 微芯公司的官方充电器设计资料的配套程序，适合从事锂电池，镍氢等充电器的程序设计参考。-Mirochip company s design document and it s attached source code
FM25V02
- FM25V02 的驱动程序,该程序实现了在ATMEL 9200 CPU上 对FM2V02芯片的读写驱动程序。-FM25V02 drive program, on atmel 9200 platform.
C8051F340_SSD1963_RGB-MODEl-PROGRAM
- C8051F340+SSD1963_RGB 模板程序，程序以HYD3.5-HX8369-A-SPIRGB为例，带TSC2046触摸功能-C8051F340+SSD1963_RGB MODEL PROGRAM，this program use HYD3.5-HX8369-A-SPIRGB as example ,and have tsc2046 touch function
MCU_TCPIP_uIP_Application
- 使用uIP的说明文档和注意事项 还有源码分析等 会对大家有所帮助-About uIP1.0 helpful
485modbus
- 主要是mega8单片机通过485总线控制16路继电器的开合，带继电器状态的返回，与上位机通信采用modbus协议-Mainly mega8 single-chip microcomputer by 485 bus control opening and closing as 16 road relay relay status returns, communicate with PC using modbus protocol
Light-water
- 利用msp430单片机的定时器timeA定时产生中断，在中断中按顺序依次点亮led灯，结束后，再依次熄灭led灯。-Use msp430 microcontroller timer timeA timer generates an interrupt, the interrupt led lights lit in sequence, after the end, and then turn off led lights.
MS5607
- 温度和大气压测量 已经通过测试 MCU用的是C8051F340-Temperature and barometric pressure measurement has been tested using a C8051F340 MCU
remindianzu-shumaguan
- 基于C51单片机的热敏电阻测试数码管显示-Thermistor C51 microcontroller based digital display test
main_rx
- CC2510简单的数据接收，不含应答机制，可以在开发过程中，用作对发射端的数据接收测试，本例程，接收数据用的的是DMA方式。-CC2510 simple data reception, excluding response mechanism, can be in the process of development, used as a test to launch the data receiving, this routine, receive data using DMA mode.
usb_descriptors
- USB报表，Mtouch 十点报表以及鼠标键盘，能实现一次性上发10个触摸点的数据，实现的平台:基于PIC32单片红外触屏- USB报表 Mtouch 十点报表，能实现一次性上发10触摸点的数据，实现的平台基于PIC32单片红外触屏
hongwaijiema
- 普通c51红外解码，数码管显示键值。 -Common c51 IR decoding, digital display keys. Common c51 IR decoding, digital display keys.
MCU-Software
- 该软件是一款步进电机的驱动程序，基于AT89C52单片平台，实现了串口通信与PWM斩波控制，改程序运行稳定！-The software is a stepper motor driver, based on AT89C52 single-chip platform to achieve the serial communication with the PWM chopper control, change the program to run stable!