资源列表
CDMA-2USER
- 二用户CDMA系统，信道为加性高斯信道，使用BPSK调制，15位M序列扩频，可以正确解扩解调。 输出为2用户的基带信号、扩频信号、PSK调制信号、解调信号的时域和频域特性，给出两个用户分别的误码率。 -Second, the user CDMA system, channel for the additive Gaussian channel, using BPSK modulation, 15 M Sequence Spread Spectrum, you can correct demo
RSSI
- 基于RSSI的定位，已知发射节点的发射信号强度, 接收节点根据接收信号的强度, 计算出传播损耗, 利用理论的或经验的信号传播模型将传播损耗转化为距离, 然后再计算出节点的位置。-RSSI-based positioning, known to the launch of the launch signal strength node, receiving node based on received signal strength to calculate the spread of wear
ourdev_575304
- LABVIEW数据采集及测试程序,很有用哦-LABVIEW data acquisition and testing procedures
SnakeBite
- 贪食蛇小游戏，用python写的，很不错，给大家借鉴借鉴。注意不要玩的太入迷哦-Snake bite，written in python. It s fantastic and you can learn a lot from it. Take care,don t be hooked by it!!!
matlab
- matlab写的QP-solver程序，可以直接再matalab R2006a下运行。有效提高运算速度-matlab written procedure QP-solver can be directly re-run matalab R2006a. Effectively improve the computation speed
coordinate
- 坐标转换，用来实现大地坐标到直角坐标，直角坐标之间的转换。-coordinate
source
- 二进制通信系统的蒙特卡罗仿真。用蒙特卡罗仿真估计使用相关器或匹配滤波器的二进制通信系统的误码率 ，并画出 对SNR的图。-Binary communication system Monte-Carlo simulation. Estimated using Monte-Carlo simulation or use of binary matched filter communication system bit error rate, and draw the map of the SNR.
test
- 虚拟仪器程序中多个面板相互调用的程序示例-Labwindows panel process more than procedure calls another example of
ofdm
- 基于导频的ofdm信道估计ls 和mmse算法 -Pilot-based channel estimation of ofdm and mmse algorithm ls
sdram
- 在ISE开发环境下的单速率SDRAM简单读写控制器设计，用的是verilog硬件描述语言-ISE development environment in a single-rate SDRAM controller read and write simple design, using the verilog hardware descr iption language
VB-net-Access
- VB网吧计费管理系统Access版.rar-VBAccess
China
- vb+mo,用来做地图投影，加载图层，等等，都可以用的上的-shp file,can be use in vb+mo