资源列表
4MTR
- MSP430接4M晶振串口通信程序，给大家只供参考用，还请各位多多指教-MSP430 then 4M crystal serial communication program for everyone to use for reference only, but also the exhibitions please
4oLQDQ
- 1. 直接烧写进单片机即可2. 按SW19~SW22 四个独立按键 分别代表4路抢答器按键 3.C语言编的。-1. Direct burning can be written into the microcontroller 2. By SW19 ~ SW22 four separate buttons representing the 4-way Responder button 3.C language compiled.
4PMW
- 利用8051f单片机产生4通道的PWM波形-The use of four-channel 8051f MCU PWM waveform generated
4ulaza
- Proteus, 4 inputs, 1 output
4x4
- C8051f020 4x4矩阵键盘程序,可以使用-mcu c8051f020 4x4
4X4juzhengjianp
- 4X4矩阵键盘C程序，已经调试好，可以直接与单片机相结合，应用很方便。-4X4JUZJP
4x4keboard
- 4x4的键盘的程序在430单片机程序，键盘是有源的，硬件电路设置成的是上拉-4x4 keyboard program in 430 MCU program, the keyboard is active, the hardware circuit set the pull-up
5-11
- 在dos下编程得到pci9052的总线号。设备号和功能号，并获得其使用资源的信息-In the dos program to be pci9052 under the bus number. Device number and function number, and get information on their use of resources
5-codes
- i have intersted in embedded systems & programming on 8,16,32 bit microcontrollers further development in future
5.2_tsp_test
- s3c2410tsp调试程序，调试成功的例程~~·-s3c2410tsp debugger, debug successful routine ~ ~
5
- 超声波测距源程序，通过这个程序能够满足单片机测距的基本要求-Ultrasonic Ranging source, through this program can meet the basic requirements for single chip ranging
501
- 普通型足浴盆程序代码该产品销往230V的地区-Common type foot bath program code of the product sold in 230V areas