资源列表
STC-AD
- 采用STC12C5201AD做的AD转换程序。热敏电阻用30K。-STC12C5201AD done using AD conversion process. Thermistor with 30K.
STC-AD2COM
- 采用STC12C5201AD做的AD转换到串口通信程序。采用内部时钟，初值自动设置。-STC12C5201AD to do with AD converted to serial port communication program. The introduction of internal clock, the initial value is automatically set.
Serial
- 嵌入式串口实验程序，用ADS1.2编辑，嵌入式芯片是ARM3-Embedded Serial experimental procedure, using ADS1.2 editor, embedded chips are ARM300
keyboard(C)
- 嵌入式键盘及LED实验-C语言实现，用ADS1.2编辑，嵌入式芯片是ARM300 -Embedded keypad and LED test-C language implementation, with ADS1.2 editor, embedded chips are ARM300
Keyboard(asm)
- 嵌入式系统键盘及LED驱动实验-汇编语言实现，用ADS1.2编辑，嵌入式芯片是ARM3-Keyboard and LED-driven embedded systems test- assembly language implementation, with ADS1.2 editor, embedded chips are ARM300
DAsort
- 嵌入式系统DA接口实验，用ADS1.2编辑，嵌入式芯片是ARM3-Embedded Systems DA Interface Experiment, using ADS1.2 editor, embedded chips are ARM300
ADsort
- 嵌入式系统AD接口实验，用ADS1.2编辑，嵌入式芯片是ARM3-Embedded Systems AD Interface Experiment, using ADS1.2 editor, embedded chips are ARM300
MotorControl
- 嵌入式 电机控制-C语言实现，嵌入式芯片是ARM300 -Embedded motor control-C language implementation, the embedded chip is ARM300
motocontrol(asm)
- 嵌入式电机控制-汇编语言实现，用ADS1.2编辑，嵌入式芯片是ARM3-Embedded motor control- assembly language implementation, with ADS1.2 editor, embedded chips are ARM300
avrplj
- M16单片机做的频率计希望跟大家共同交流下-plj
motor_control_wince
- 基于2410开发板在wince平台上的(步进电机控制)-Based on the 2410 development board in the wince platform, "stepper motor control"
yanshi
- mega16单片机的延时程序，使用定时器，可以比较一下和软件延时的区别。-mega16 MCU delay procedures, the use of timers, you can compare and software delay difference.