资源列表
Economic-Dispatching-using-Nested-PSO
- Economic Dispatching using Nested PSO
stm32-center-project
- 无线室温采集系统的中心固件源码，使用stm32作为主控，运行ucos3 ，加入fatfs文件系统实时存储通过无线模块接收的终端数据-Wireless room temperature collection system center firmware source, the use of stm32 as the master, running ucos3, adding fatfs file system real-time storage through the wireless modul
myWhiten
- 此程序用于ica独立成分分析中的白化过程，可以消除数据间的相关性。-This program is used ica independent component analysis bleaching process, can eliminate the correlation between the data.
DLZH
- 电流滞环控制的简单仿真，主要体现了它的基本控制原理，波形生成方法-Current hysteresis loop simulation
ninubi
- 基于s-function的DFIG模型，输入dq轴电压、转差、驱动转矩，输出dq轴电流、电机转速-s-function model of DFIG based input dq-axis voltage, slip, drive torque, output current dq-axis motor speed
ConverterGrid
- DFIG的电网侧变换器模型，内含可以设置的理想电网电压正弦波-Over grid voltage sine wave DFIG grid side converter model, you can set the contents of
windturbine
- 用于风力发电的风力机模型，其中的function模块参数根据不同的风机自己更改。-For wind power wind turbine model, in which the function module parameters change depending on the fan themselves.
converter-of-axis
- 采用幅值恒等原则建立的三相到两相静止坐标系和两相静止坐标系到三相坐标系的变换-Constant amplitude using the principles established by the three-phase to two-phase stationary coordinate system and the two-phase stationary coordinate system to transform the three-phase coordinate system
Michalsky
- 此源码是太阳位置角追踪的天文算法代码。适用时间为1949~2050年-This is the algorithm of accurate solar position
tbxmanager
- 包含多个程序，MPC（模型预测控制），Energy hub建模-Contains multiple programs, MPC (model predictive control), Energy hub modeling
SSG_model
- 逆变器Simulink下的通用模型，便于研究其动态特性-Inverter Simulink under the general model to facilitate the study of its dynamic characteristics
Kfloppy
- Kfloppy is a tool for fanuc robots this software runs only on win98 and it works to make backups of robots