资源列表
DSP--Mfile
- This code contains information about the DSP project. I hope to be useful
SPEECHX
- . The normalized least mean square is the most popular due to its simplicity. The stability of the basic NLMS is controlled by a fixed step size. This parameter also governs the rate of convergence, speed of tracking ability and the amount of steady-
SVPWM
- 这段代码是针对三相电压型逆变器提出的，输入直流电，通过三相全桥得到三相相位互差120度的正弦波电压，控制开关管使用的是SVPWM程序。-This code for 3-phase voltage type inverter is proposed, and the input dc, three phase is obtained by three-phase full bridge phase difference of 120 degrees each sine-wave voltage,
step_motor
- 基于TI公司的TMS320F28335的DSP来控制步进电机的程序。开发环境为CCS3.3。-Based on TI s TMS320F28335 the stepper motor program. Development environment for the CCS3.3.
VMD642_mem
- ＣＣＳ３.３ｌｏａｄ程序之后，硬件仿真运行检查内存是否有错误-After CCS3.3load programs, hardware simulation run to check memory for errors
TMS320X281x-DSP-CAN
- 基于CAN总线，实现DSP2812芯片的收发程序-Based on CAN bus, the DSP2812 chip transceiver procedures
bookexercises
- 使用CCS可以打开的DSP28027例程，带有Word文档-CCS can be opened using the DSP28027 routine with a Word document
DSP-daima
- TMS320F280X型DSP直流电机控制，I2C，E2PROM等程序-TMS320F280X type DSP DC motor control, I2C, E2PROM and other procedures
src
- 67系列dspemac通信例程，不用上层协议直接与上位机通信-67 series dsp emac communication routines, without upper-layer protocol directly with the host computer communications
I2C
- 基于DSP2812的IIC驱动程序，测试使用正常！-Based IIC driver DSP2812, the test using normal!
DSP
- DSP在开发过程中遇到的问题总结，还包括一些错误的解决方法-in the development process of the problems of the DSP encountered in the summary, but also includes some wrong solutions
C64xDSPLIB_v
- c64系列dsplib库，主要有FFT和数字滤波函数，用于数字信号处理-c64 series dsplib library, there are FFT and digital filtering functions for digital signal processing