资源列表
renji
- 基于DSP的人机交互方面的系统程序源，其中有部分例子和系统初始化设置。-DSP-based human-computer interaction aspects of the system program sources, including some examples, and system initialization settings.
stepmotor-knowledge
- 有关步进电机知识相关文档的整理，还比较全面，有相关论文和程序做指导 -Stepper motor knowledge about the collation of relevant documents, but also more comprehensive, relevant papers and guidance program to do
DSPNETprogramme
- DM642向pc传输数据的例程，pc端用vc写了个接受程序-DM642 routines to transfer data to pc, pc side with vc wrote a program to accept
STC11L04
- STC11L04++A3966，，，步进电机驱动程序，-STC11L04++ A3966,,, stepper motor drivers,
11
- C8051单片机驱动步进电机转速与晶振，中断设置数计算公式-C8051 MCU to drive a stepper motor speed and crystal, the number of interrupts set formula .....
dianji
- l298n两相步进电机的正转 反转 加速 减速程序-This forward stepping motor reverse
dsk6455_v2
- 该资源中包括6455srio、led等模块的源代码，可以在ccs中直接使用。-The resource includess serio and led module examples.
b
- 直流电机实用C程序 不用谢了 很实用 不看后悔的-DC Utility C program not a very practical Bukanhouhui thank the
dsPIC33FJ128GP706_2011_0611
- dsPIC33FJ128GP706 这个芯片的测试程序，主要实现IO口设置、AD设置、定时器设置、液晶控制、RS232设置、I2C总线传输模式等方法。-dsPIC33FJ128GP706,the chip testing procedures, the main achievement of the IO port settings, AD settings, timer settings, LCD control, RS232 set, I2C bus transfer mode and ot
10_ADC02
- 模拟生产正弦波，生产的正弦波通过A/D转换送到DSP中，采样-Simulation of production sine, sine wave produced by the A/D converter to the DSP, the sampling
08_Sci03
- 通过SCI与PC机的串口通信来控制LED D1-D6的运行方式。根据通信协议，PC机发送一条指令给2812，2812通过SCIA接收到指令后，进行解析，然后根据PC机 的指令来运行D1-D6。-SCI and the PC through serial communication to control the LED D1-D6 runs. According to protocol, PC sends a command to 2812,2812 to the instruction rece
Adc_T1_start
- AD采样频率为10K，序列发生器SEQ1和SEQ2级联成一个16通道的序列发生器， 采样模式采用顺序采样。利用通用定时器T1的周期中断来触发AD转换。-AD sampling frequency of 10K, the sequence generator SEQ1 and SEQ2 cascaded into a 16-channel sequencer, sampling mode with sequential sampling. The use of general-purpose ti