资源列表
dcshuangjixingcontorl
- 基于dsp2407的直流双极性双闭环可逆控制程序，完整的源代码，word格式，直接复制到css2000中运行，运行成功-Based on dsp2407 dc dual polarity double closed loop control procedures, reversible complete source code, word format, copy css2000 to run, run of success
L298
- 仅仅使用L298驱动芯片，主控为51单片机，在keil中调试测过，专门驱动步进电机的！不是直流电机。-Just use the L298 driver chip, the master microcontroller 51, in keil debugging measured before, specifically to drive stepper motor! Not a DC motor.
dsp
- Xilinx DSp solutions Guide
flashboot
- 该程序实现了flash的烧写，并实现了程序自动引导加载-The program implements the flash programmer, and to achieve the program automatically boot loader
dsPIC33F-Demo-for-Explorer-16-Board
- explorer 16开发板，AD转换实时显示。-RTC_AD_LED conver
4-20ma
- TINA下绘制的 工业4-20mA 传感器信号采集用的隔离放大器。能将4-20mA的电流信号转换为0~3V的电压信号，方便设备采样。-TINA drawn under the Industrial 4-20mA sensor signal acquisition using isolation amplifiers. Can 4-20mA current signal into a 0 ~ 3V voltage signal to facilitate the sampling equipmen
2812series_communication_codes
- 和众达2812串行通信源程序，头文件及编译中间结果都在-dsp2812 series communication
bjdj
- 采用C语言编程，用51单片机控制的三相步进电机设计及其驱动电路设计-Using C language programming, with 51 three-phase microprocessor controlled stepper motor drive circuit design and design
5509_FIR
- 基于TI 5509A的FIR滤波器代码，C语言写成。包含基于CCS3.3的完整工程，已运行通过。-FIR filter source code for TI 5509A DSP
1324
- proteus仿真直流电机温控线系统才做简单 绝对好东西分享一下-proteus simulation line of DC motor temperature control system was definitely a good thing to do simple share
FFT-physical-meaning-and-mass
- FFT的过程和物理意义详解(是用于DSP，凌阳等)-The FFT process and the physical meaning explain (for DSP, Sunplus, etc.)