资源列表
Occam1DCSEM_V3.9.1
- 1D occam 反演, 正演包括了CSEM、MT，建立模型用于海洋地球物理勘探。-Inversion of 1D occam
Microgrid
- 微网系统 分布式电源 pscad环境中运行，显示电网各种参数-microgrid、Distributed power 、pscad
GABPMATLAB
- 利用遗传算法优化BP神经网络权值和阈值，然后进行训练，利用训练好的模型进行预估。附实例-The use of genetic algorithm to optimize BP neural network weights and thresholds, and then training, training a good use of forecast models. Attached examples
APF
- 有源滤波器，主要应用于电力系统谐波抑制和无功补偿-Activ power F
danjiwuqiongda
- psasp用单机无穷大系统，可用于电力系统仿真等分析，模型相对简单-psasp danjiwuqiongda
MPPT-PO
- 2812控制光伏发电系统，单相并网控制程序，采用C语言编写，完整的工程文件。-2812 to control photovoltaic power generation system, single-phase network control procedures, using C language, complete project file.
Rayleigh_inversion
- 此程序为瑞雷面波最小二乘反演程序，适合于初步接触瑞雷面波反演研究相关方面的人员。-This procedure for the Rayleigh wave least squares inversion procedure is suitable for the initial contact Rayleigh wave inversion research personnel.
PMSG-MPPT
- 永磁同步电机的最大功率跟踪仿真模型。 PMSG MPPT。-Maximum power tracking simulation of permanent magnet synchronous motor model.
mppt
- S 函数 编写的 最大功率捕获程序 在MATLAB上 调试成功 请大家参考-S function to write the greatest power capture program in MATLAB debugging success, please refer to
PFC_2PI
- 用matlab做的单相boost PFC的仿真模型，功率11K，采用PI双闭环数字控制方法，波形较好。-Using matlab to do the simulation model of single-phase boost PFC power 11K PI double closed-loop digital control method, the waveform is better.
Torque_distribution
- 开关磁阻电机（SRM）基于cos转矩分配函数的相转矩瞬时控制策略，效果理想-Switched Reluctance Motor (SRM) based on the torque distribution function cos instantaneous phase torque control strategy, the results are satisfactory
free-scada-src
- freescada软件的源代码，一个组态软件的源代码，c++编写的组态软件的开源代码。-freescada software source code, A complete configuration software source code, c++ to write the configuration software source code.