资源列表
firmwareVna
- 矢量分析仪cypress an2135源码-vector analyzer cypress an2135 FOSS
用Proteus 7.2 仿真的51单片机128x64液晶滚屏显示
- 用Proteus 7.2 仿真的51单片机128x64液晶滚屏显示，包括源程序和仿真文件。,Proteus 7.2 Simulation with 51 Singlechip Scroll 128X64 LCD display, including the source code and simulation files.
FLVtoMPEG4Source
- 将FLV格式文件转换成MPEG4格式文件c语言源程序-.FLV file convert to .MPEG4 file
4164
- 为了下载文件，必须上传一个空的文件-for up load
1234567
- 如图1所示门形支架的一个立柱上用转轴固定一根U型导轨，导轨的另一端可由固定在顶梁上的电机控制其上下运动，使小球在导轨上按要求灵活滚动或移位。导轨以转轴处为原点，以厘米（cm）为单位标注位置（见图中放大部分）-As shown in Figure 1 a column of the portal type bracket with a fixed rotating shaft U-type guide rail and the other end of the guide rail can be
123123
- 纸牌和谈球的分数修改和读取，通过内存读写和驱动过保护完成！-Solitaire peace talks ball changes and reading scores, through the protection of the memory read and write and drive over to complete!
PortTest
- 用于多串口的数据发送、接收的小程序，程序中是两个串口，可以扩展到多个-For many serial data to send, receive a small program, the program is two serial ports, can be extended to multiple
44B0_UCOS+Uart
- 44b0+ucos dgfgfjhjkjkjkjjl-44b0 OUT dgfgfjhjkjkjkjjl
Ernie
- 摇奖机利用线程控制获得随机数,并保存到指定位置.
2635546465
- 此程序为应用51单片机汇编编制的对无线遥控解码芯片PT2262的软件解码，解码程序经测试OK。-This program compiled for the application compiled on 51 single-chip decoder chip PT2262 wireless remote control software decoding, decoding procedure tested OK.
test-serial
- 利用C51编写串口测试程序，借助于虚拟串口，在PROTUES中进行仿真，串口助手中可以接收到单片机发来的数据。-C51 prepared using serial testing procedures, by means of virtual serial ports in PROTUES the simulation, the assistant can receive serial data sent to the microcontroller.
1602-display-51
- STC89C52例程及原理图,公司标准程序，运行无错，包括其中的1602串口显示51参考程序部分-STC89C52 routines and principle diagram, the company s standard procedure, error-free operation, including 1602 serial display 51 reference program