资源列表
复件EX5
- 用于步进电机的DSP控制,用于小型机器人的设计-for the stepper motor control DSP for small robot design
hamm7484
- Hamming（7/4，8/4）纠错码的编解码器-hanmming(7/4,8/4) error correction codes s docode and encode
sin8_LED
- Sine Generator for C6713
shoufa
- 这是一个关于RS232串行通讯的程序，它实现了把接收到的数据立即再发回去的功能-This is an RS232 serial communications program, which implements the back function of the received data immediately recurrence
PTZ_89C51_D
- 云台镜头控制板的源程序，采用89C51单片机，C语言源代码，实际测试通过。 环境STC51单片机配11.0592晶振，支持协议pelco-d，采用485和RS232均通过测试，2400BPS。地址码按默认1.**是51芯片上的程序可不是电脑PC上的控制程序。测试用电脑上和用监控键盘均可以控制。编译通过Keil_C.-PTZ control panel source 89C51 microcontroller C language source code, through the actual t
add-leds-speed
- C8051f120的AD程序，调节电位器控制八个led灯的亮灭和闪烁频率-C8051f120 the AD process, adjust potentiometer control eight led lights out and flicker frequency
LPM3
- msp430F149,说明：此程序运行在LPM3 MSP430通常在4秒的时间间隔，脉冲P3.4。 WDT ISR用来唤醒系统。- Descr iption: This program operates MSP430 normally in LPM3, pulsing P3.4 at 4 second intervals. WDT ISR used to wake-up system.
ds18b20
- 采集DS18B20的温度 并显示于数码管上-DS18B20 temperature acquisition and display on the digital
hld
- 程序是东西红灯亮30秒，南北绿灯亮24秒 东西红灯亮，南北绿灯闪3秒然后熄灭 黄灯亮3秒-Program is what turns red, 30 seconds, north and south green light 24 seconds Red light, the north and south green light flash for 3 seconds and then go out Yellow lights for 3 seconds
Voltage
- 电压显示数据处理程序，用于电压计算，初始化数据。-Voltage display data processing procedures for the calculation of voltage, initialization data.
HC-SR04-ultrasonic
- 利用C51单片机的IO口给超声波模块HC-SR04发送指令，实行超声波测距功能-Using C51 microcontroller IO port to send HC- SR04 ultrasonic module instruction, implements the function of ultrasonic ranging
voice_codec
- cantus录音驱动代码 - voice驱动-cantus voice drivce