资源列表
seg8
- AVR单片机控制八段数码管显示的C原代码及说明-AVR single-chip microcomputer to control eight digital tube display C source code and descr iption
lcd12864
- 程序功能：在液晶上用串行数据通信方式依次显示常用ASCII码 跳线设置：将跳线座J5的2脚和3脚(-)用短路帽短接 测试说明：观察液晶显示-Program features: LCD used in the serial data communication commonly used ASCII code sequence shows the jumper settings: Jumper Block J5 to 2 feet and 3 feet (-) shorted cap wi
24C02and24C256sw
- 一个通用的24C01－24C256共9种EEPROM的字节读写操作程序，此程序有五个入口条件.-A generic 24C01-24C256 A total of nine kinds of EEPROM byte read and write operating procedures, this procedure has five entry conditions.
leds
- 利用蓝牙控制灯的亮与灭间隔时间，蓝牙的一个应用-Bluetooth application
0326_hongwai
- 采用单片机外部中断对红外遥控器进行解码应用。-MCU external interrupt infrared remote control decoding applications.
rs485-and-pic
- 基于pic16f系列的rs485通讯程序设计-PIC16F series based on the RS485 communication program design
hongwai
- 基于msp430的1838T红外接收串口显示程序，可将红外遥控器32位遥控器识别码和键码以十六进制显示-Based on the msp430 1838T infrared receiver serial display program can be infrared remote control 32 remote control ID and the key code in hexadecimal
spi-temperature
- 利用MSP430单片机测量温度，并通过SPI协议将所测得温度传送到主机-Use MSP430 microcontroller to measure temperature, and through SPI protocol to the measured temperature is transferred to the host
anjianzijiayi
- 0-99数码管按键自加一，调试过的，mega16芯片，相互学习-mega16chip shumaguan press
c_com1
- DOS环境下如何利用C语言编程控制串口进行通信发送接收数据。-DOS below how to use the C programming language to control COM port to communicate, send and receive data.
emb-asgnment
- ascending, descending and other assembly code
jake
- An example for simulation the Jake s model and the classic example.